Vmware 5V0-42.21 VMware SD-WAN Design and Deploy Skills Online Training

The Vmware 5V0-42.21 VMware SD-WAN Design and Deploy Skills Online Training of Exam4Training can ensure you pass your first time to participate in the Vmware certification 5V0-42.21 exam.Exam4Training providing Vmware 5V0-42.21 VMware SD-WAN Design and Deploy Skills Online Training are very close to the content of the formal examination. Through our short-term special training You can quickly grasp IT professional knowledge, and then have a good preparation for your VMware SD-WAN Design and Deploy Skills exam. We promise that we will do our best to help you pass the VMware SD-WAN Design and Deploy 2021 5V0-42.21 exam.

Page 1 of 2

1. Which statement describes a characteristic of VMware SU-WAN Edge (VCL) clustering?

2. An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.

3. Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.

What are some of the needed steps to achieve the requirements above?

4. What is considered a typical VMware SD-WAN use case?

5. Company a has recently acquired Company B, which has two remote office. Company A is using VMware hosted Cloud Gateways, and Company B is using a VMware SD-WAN with a Hub-Spoke topology.

Which VEware Cloud VPN solution an administrator configure to establish connectivity between the offices of Company A and Company B?

6. Refer to the exhibit.





An MSP is designing a solution for a merger of Customer A and Customer B to Customer A’s enterprise. Due to overlapping IP addresses and security requirements, the segments with the same names between Customer A and Customer A cannot be merged.

Based on the graphic and the requirements, how many new segments need to be configured in the VMware SD-WAN Orchestrator?

7. A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their existing provider (idp) for access to their Orchestrator account.

Which authentication protocol is supported?

8. Which form factor can a customer use to deploy VMware SD WAN Edge?

9. A network architect is designing a VMware SD-WAN architect for customer using VMware hosted VCO and VCGs, white VCEs will be deployed at the customer’s branches and data centers. The network architect would like to achieve control plane redundancy.

Which action, if any, should be taken to meet this goal?

10. A customer has deployed VMware SD_WAN solution An administrator asked to imported additional security for traffic going to internet without investigating in new hardware solutions.


 

Latest 5V0-42.21 Dumps Valid Version with 52 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>