To fully enable Dynamic Dispatcher with Firewall Priority Queues on a Security Gateway, run the following command in Expert mode then reboot:

To fully enable Dynamic Dispatcher with Firewall Priority Queues on a Security Gateway, run the following command in Expert mode then reboot:
A . fw ctl multik set_mode 1
B . fw ctl Dynamic_Priority_Queue on
C . fw ctl Dynamic_Priority_Queue enable
D . fw ctl multik set_mode 9

View Answer

Answer: D

Explanation:

Dynamic Dispatcher is a feature that optimizes the performance of Security Gateways with multiple CPU cores by dynamically allocating traffic to different cores based on their load and priority. Firewall Priority Queues is a feature that prioritizes traffic based on its type and importance by assigning it to different queues with different weights and limits.

To fully enable Dynamic Dispatcher with Firewall Priority Queues on a Security Gateway, you need to run the following command in Expert mode then reboot:

This command sets the multi-core mode to 9, which means that Dynamic Dispatcher is enabled with Firewall Priority Queues. The other commands are not valid or do not enable both features.

Reference: R81 Performance Tuning Administration Guide