156-835 Online Training Archives

Page 1 of 2

1. There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks.

Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

66%/33%

100%/0%

50%/50%

33%/66%

2. What is the Orchestrator?

Load balancer

Network Switch

Manager of compute and network resources, load balancer and network switch

None of above

3. What is a Security Group?

Logical group of computer and network resources

Group of security administrators

Group of security gateways

Group of appliances with enabled NGTX software blades

4. What cannot be learned from the output of lldpctl?

Distribution mode

Orchestrator’s IP

Serial number of Appliance

Appliance model

5. What is the maximum amount of Appliances within Security group in Dual-Site configuration?

6. Which is a valid requirement for a supported Maestro appliance?

10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support

At least one 10GBps line card

Nothing special as Maestro supports any Check Point appliance

Line card with double-VLAN and LLDP support

7. What type of cluster can a Security Group can be compared to?

VSLS

Load Sharing Active /Active

Active / Backup

Active / Standby

8. What is the purpose of g_tcpdump command?

Collects traffic dump from Sync network

The same as tcpdump, just on Scalable Platform

Collects traffic dump from CIN network

Collects traffic dump from all Active Appliances within Security Group

9. Browse to the Orchestrator’s WebUI

3-4-2-6-5-7-1

3-1-7-2-4-6-5

1-4-2-5-7-3-6

7-4-2-5-3-1-6

10. Orchestrator should be defined in SmartConsole as:

Orchestrator is not defined in SmartConsole

Check Point host

Security Gateway

Host

Page 2 of 2

11. How many power supplies are presented on MHO-170?

1 with option for 2

12. What cannot be learned from the output of asg perf -v -p command?

Average CPU usage on Appliances

Real-time throughput

Average CPU usage on Orchestrators

Per-path distribution

13. What is the minimal amount of cables needed in order to connect an Appliance to an Orchestrator?

Three cables: uplink, downlink, SYNC

One Downlink cable only

Two cables: one uplink and one downlink

Four cables: uplink, downlink, SYNC and Management

14. On MHO-170 C In default configuration, what are GAIA names of Security Group Management ports?

eth1-Mgmt1 and eth1-Mgmt2

eth1-Mgmt1 and eth2-Mgmt1

eth1-Mgmt1 and eth1-Mgmt3

eth1-Mgmt3 and eth1-Mgmt4

15. What is the maximum amount of Appliances within the same Security Group?