How can the service provider set a static IP address for the Unity storage system management interface?

A service provider is installing a Unity storage system for an end-user. The end-user is concerned about network security and will not allow the service provider access to the network.

How can the service provider set a static IP address for the Unity storage system management interface?
A . Use the embedded InitCLI tool
B . Connect directly to the service ports and configure the networking through UEMCLI
C . Use an IPMI serial over LAN connection
D . Use the Connection Utility to create a configuration file

Answer: D

Explanation:

When setting up the system, and a network connection cannot be used, use the Unity Connection Utility to create a configuration file. Save the file to an usb drive, and put the drive into the usb port of the SP Using UEMCLI requires an ip address to the system, thus accessing the network to change the IP address. But therefore the system must already be accessible from the network.

Which in this case is not allowed.