Based on the output from RouterA, what are two possible reasons for the failure?

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0.

Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

A. The cable that is connected to S0/0 on RouterA is faulty.

B. Interface S0/0 on RouterB is administratively down.

C. Interface S0/0 on RouterA is configured with an incorrect subnet mask.

D. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.

E. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

F. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.

Answer: E, F

Explanation: http://www.cisco.com/en/US/docs/routers/access/800/819/software/configuration/Guide/6ser_conf.html

Latest 200-105 Dumps Valid Version with 312 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments