Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
A . lldp timer
B . lldp holdtimt
C . lldp reinit
D . lldp tlv-select

View Answer

Answer: C

Explanation:

+ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it

+ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface

+ lldp timer rate: Set the sending frequency of LLDP updates in seconds