Which two design concerns must be addressed when designing a multicast implementation? (Choose two)

Which two design concerns must be addressed when designing a multicast implementation? (Choose two)
A . only the low-order 23 bits of the MAC address are used to map IP addresses
B . only the low-order 24 bits of the MAC address are used to map IP addresses
C . only the high-order 23 bits of the MAC address are used to map IP addresses
D . only the low-order 23 bits of the IP address are used to map MAC addresses
E . the 0x01004f MAC address prefix is used for mapping IP addresses to MAC addresses
F . the 0x01005e MAC address prefix is used for mapping IP addresses to MAC addresses

Answer: DF

Explanation:

Ethernet & FDDI Multicast Addresses

– The low order bit (0x01) in the first octet indicates that this packet is a Layer 2 multicast packet. Furthermore, the “0x01005e” prefix has been reserved for use in mapping L3 IP multicast addresses into L2 MAC addresses.

– When mapping L3 to L2 addresses, the low order 23 bits of the L3 IP multicast address are mapped into the low order 23 bits of the IEEE MAC address. Notice that this results in 5 bits of information being lost.

https://www.cisco.com/networkers/nw00/pres/3200/3200_c1_Mod2_rev1.pdf

Latest 300-320 Dumps Valid Version with 725 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments