What is the result of enabling this command’?

Scenario:

The following four questions concern the Nexus 7010’ s which are configured as a vPC pair at the core of a Data Center network. You can utilize all the available show commands to answer the Questions Access to the running-configuration is not allowed.

Instructions:

Enter NX-OS commands on 7K-3 and 7K-4 to verity network operation and answer four multiple-choice questions

THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.

Click on the switch to gain access to the console of the switch. No console or enable passwords are required.

To access the multiple-choice questions, click on the numbered boxes on the loft of the top panel.

There are four multiple-choice questions with this task Be sure to answer all four questions before selecting the Next button

Topology:

Within the vpc configuration of the 7K’s. the command peer-switch is configured.

What is the result of enabling this command’?
A . Both vPC peers use the same STP root ID
B . The vPC primary switch (7K-4 in this case) also serves as the STP root to improve vPC convergence
C . The vPC secondary switch (7K-3 in this case) serves as the STP root to improve vPC performance
D . Allows 7K-3 to act as the active HSRP gateway for packets that are addressed to the MAC address of 7K-4
E . Automatically disables IP redirects on all interface VUANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the vPC peer gateway router
F . Enables faster convergence of ARP tables after the vPC peer link flaps

View Answer

Answer: A