What is causing this issue?

A deployment using AP-635S is connected to a stack of CX 6300s as shown.

The output of the snow LACPinterfaces shews the following:

What is causing this issue?
A . e0 is connected to a smart rate interface, and e1 is connected to a non-smart rate interface.
B . Spanning tree and loop protect are enabled on both AP uplink ports.
C . Each AP interface is connected to a routed-only interlace on different networks
D . The AP is configured with LACP active

View Answer

Answer: D

Explanation:

In an Aruba deployment, if an AP’s interfaces show different LACP states, it often indicates a configuration mismatch. If one interface is up and the other is blocked as shown in the output, it’s likely due to both interfaces on the AP being set to LACP active mode, which is a correct setting for establishing an LACP channel with Aruba switches like the CX 6300 series.