An administrator is planning a new cluster deployment supporting groups of 4 fault tolerant VMs. The fault tolerant systems require 8 vCPUs each.
What is the minimum number of hosts required to achieve this?
A . 4
B . 8
C . 16
D . 32
Answer: B
Which two availability features require a VM restart for recovery? (Choose two.)
Which two availability features require a VM restart for recovery? (Choose two.)
A . vSphere DPM
B . vSphere vMotion
C . vSphere Replication
D . vSphere Fault Tolerance
E . vSphere HA
Answer: C,E
What are two advantages of deploying a VDS as compared to a VSS? (Choose two.)
What are two advantages of deploying a VDS as compared to a VSS? (Choose two.)
A . Data center setup and administration are simplified by centralizing network configuration.
B . There is IPv6 support for a VD
D . 802.1Q tagging support is available.
E . Uplinks are allowed to be configured in an Active/Standby configuration.
F . Ports migrate with their clients.
Answer: A,E
What could cause a high %RDY value?
What could cause a high %RDY value?
A . Incompatible network driver
B . memory fully allocated
C . too many vCPUs configured
D . disk latency greater than 2ms
Answer: C
When enabled, what ensures only signed drivers can load into a virtual machine?
When enabled, what ensures only signed drivers can load into a virtual machine?
A . Secure Boot
B . lockdown mode
C . micro-segmentation
D . TPM
Answer: A
How can the administrator centralize the virtual networking configuration so the IT team utilizes time more efficiently?
An administrator is concerned about the amount of time the IT team takes to create multiple VLANs in a very dynamic vSphere environment.
The environment has these parameters:
– All virtual networking utilizes vSphere Standard Switches with uplinks to a Cisco Infrastructure
– Activities require 5-10 VLANs being created or removed every couple of days
– The IT team has three members
How can the administrator centralize the virtual networking configuration so the IT team utilizes time more efficiently?
A . Deploy a vRealize Orchestrator (vRO) appliance.
B . Create and use a vSphere Distributed Switch (VDS).
C . Enable and configure Storage I/O Control (SIOC).
D . Enable and configure vSphere Network I/O Control (NIOC).
Answer: B
Which VDS teaming policy should be chosen to ensure maximum availability across both uplinks?
An ESXi host is limited to two 1GbE physical NICs to support VM traffic.
Which VDS teaming policy should be chosen to ensure maximum availability across both uplinks?
A . Route Based on IP Hash
B . Route Based on Originating Virtual Port
C . Route Based on Physical NIC Load
D . Route Based on Source MAC
Answer: C
How is vCenter HA different from vSphere HA?
How is vCenter HA different from vSphere HA?
A . vCenter HA requires only an active and passive node.
B . vCenter HA requires an external Platform Services Controller.
C . vCenter HA requires Fault Tolerance.
D . vCenter HA requires an active, passive, and witness node.
Answer: D
A vCenter High Availability cluster consists of how many vCenter Server Appliance instances?
A vCenter High Availability cluster consists of how many vCenter Server Appliance instances?
A . 2
B . 3
C . 4
D . 5
Answer: B
Which VM storage policy rule category ensures all VMs for a department are on the same datastore?
Which VM storage policy rule category ensures all VMs for a department are on the same datastore?
A . Capability
B . Data Service
C . Host
D . Tag
Answer: D