Which two settings should be turned on to meet the requirements?

A consultant is setting up a new vSphere cluster. Customer requirements are as follows: * VMs should automatically failover to another host if the host crashes * Host CPU and Memory resources should be evenly balanced * New VMs should be placed on the host with the most resources available...

August 26, 2021 No Comments READ MORE +

What network changes need to be made to correct the issues?

After a recent installation using a flat switch, a consultant notices issues migrating the Nutanix nodes to the customer’s network. The customer states that they are using VLANs on the production switch but not on the dedicated switch for IPMI. The customer does not require a manual configuration of the...

August 25, 2021 No Comments READ MORE +

Which solution should the consultant use?

Refer to the exhibit. A consultant is installing AOS 5.10 and ESXi 6.5 on three nodes. During the Foundation process, ESXi 6.5 is not available as one of the choices for hypervisor. Which solution should the consultant use?A . Upload ESXi image to /home/Nutanix/foundation/nos/hypervisor/esx.B . Restart Foundation VM and refresh...

August 25, 2021 No Comments READ MORE +

Which command should be used to begin the process?

During a six-node cluster deployment, one node fails to image successfully and Foundation is unable to automatically configure the cluster. The consultant decides to manually complete cluster formation with the successful nodes, then expand the cluster with the remaining unconfigured node. Which command should be used to begin the process?A...

August 24, 2021 No Comments READ MORE +

What is the cause for the connectivity failure to the FVM?

A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following: * The consultant’s laptop and Nutanix nodes are plugged into a flat switch. * The laptop, switch and nodes are plugged...

August 24, 2021 No Comments READ MORE +

Where in the Support Portal is the Best Practices guide for vSphere Networking located?

Where in the Support Portal is the Best Practices guide for vSphere Networking located?A . Product NoticesB . Solutions DocumentationC . Software DocumentationD . Knowledge BaseView AnswerAnswer: B

August 23, 2021 No Comments READ MORE +

Which configuration is causing this issue?

A consultant creates a new cluster using ESXi as the hypervisor. After creating the cluster, the consultant begins to run Life Cycle Manager (LCM) updates. During the LCM upgrade pre-checks, an error is returned. Which configuration is causing this issue?A . ESXi cluster admission control is disabled.B . ESXi cluster...

August 23, 2021 No Comments READ MORE +

Which load balancing method should be used?

A customer has an ESXi Cluster with two 10GbE NICs on each node with the following requirements: * Solution must follow Nutanix Best Practices * Network configuration should be redundant * A vSphere Standard Switch must be utilized Which load balancing method should be used?A . Route based on originating...

August 22, 2021 No Comments READ MORE +

How can the consultant access Foundation-as-a-Service (FaaS)?

A customer would like to re-image an existing cluster. The Foundation Applet and Foundation VM is unavailable to them. How can the consultant access Foundation-as-a-Service (FaaS)?A . Through <cluster-IP> :9443B . Through <cluster-IP> :8000C . Through <CVM-IP> :9443D . Through <CVM-IP> :8000View AnswerAnswer: D

August 22, 2021 No Comments READ MORE +

What should the consultant verify to resolve the issue?

A customer has a G6 AHV cluster with 4x10GbE NICs on each node and the following configuration: * Networking is set to default * Only two NICs are connected The customer receives the following critical message: The NIC is disconnected from the switch, or the switchport is failing. What should...

August 22, 2021 No Comments READ MORE +