Category: NCSC Level-1

For a new AHV cluster installation, a customer has 20 NX-8155-G6 nodes with quad port SFP NICs. The customer wants to meet the following guidelines: * Take advantage of all available 10GbE links * Achieve maximum throughput per VM * Use of redundant ToR switches * Fastest reconvergence during link failure How should the...

Which subnet is reserved for internal connectivity within a Nutanix Cluster?A . 192.168.5.0/24B . 192.168.254.0/24C . 192.168.5.0/23D . 192.168.5.0/26 View Answer Answer: A...

A consultant creates a four-node AHV cluster with two 1GbE (eth0, etc1) and two 10GbE (eth2, eth3) NICs per node. The 1GbE NICs will not be placed into service, but the customer wants the network to be preconfigured for their eventual use. The consultant removes the 1GbE NIC from the default bond and creates...

A consultant has deployed a new Nutanix AHV cluster with Foundation. The customer requests separating the management and production traffic in the CVM. Which feature should the consultant configure?A . Micro-segmentationB . Multi-homingC . Network SegmentationD . VLAN Tagging View Answer Answer: B...

A consultant creates a Windows VM after installing a new Nutanix cluster running AHV. The consultant has statically assigned an IP address to the VM but it is unable to communicate on the network. Which action should the consultant take to resolve this issue?A . Confirm that IPv6 is enabled on the guest VC...

While preparing for a new four-node cluster installation, the consultant has a Tech Review Call with the customer. The hardware is as follows: * 4 nodes in 1 Block * 8 x 10 GbE Ports * 4 x 1 GbE IPMI Ports * Adequate Ethernet ports are available * Ethernet cables are correct and...

A customer wants to know the details of network validation testing. Where can the consultant find this information?A . Handover checklistB . Test planC . Operations GuidesD . As-Built Guide View Answer Answer: A...

A consultant is planning an installation and needs to collect configuration items to be used during the install. The data needed from the customer are IP addresses, Gateway, DNS servers, and NTP Servers. Which Cluster Deployment document must be completed with the customer?A . Project PlanB . Operations GuideC . QuestionnaireD . Technical Checklist...

During a technical call with a customer, it is identified that this installation will be software only on Dell servers. The out-of-band management interfaces will not be given IP addresses until the consultant is onsite. Which Foundation method should be used for this type of installation?A . Bare metal using iDRAC MAC addresses.B ....

Where can a consultant find Nutanix Enablement Starter Packs (ESPs)?A . In the Partner PortalB . In the Nutanix .NEXT Community ForumC . In the Support PortalD . In the Services section of the Nutanix website. View Answer Answer: A...