- All Exams Instant Download
How should the administrator configure user interfaces on the Comware switch?
A network administrator needs to restrict access to the console port of an HPE Comware switch. When a user connects to the console port and opens a terminal session, the switch should prompt the user for a password. How should the administrator configure user interfaces on the Comware switch?A ....
How should the administrator configure the physical switch-to-switch interfaces to accomplish these goals?
Refer to the exhibit. The switches in the exhibit are all HP Comware switches that run Multiple Spanning Tree Protocol (MSTP). The network administrator wants to ensure that each switch-to-switch link is in its own subnet. The administrator also wants to make sure that all of the links are available...
What is the correct setup to accomplish this?
Exhibit1. Exhibit 2 A network administrator wants to create a backup IP route to 10.1.20.0/24 on Switch-1. The backup route should use Link 2, and it should only be used if Link 1 is down. What is the correct setup to accomplish this?A . an IP route through 10.0.2.2 with...
Which credential is required to validate SNMPv2c write requests?
Which credential is required to validate SNMPv2c write requests?A . Community stringB . SchemeC . MD5 authkeyD . AAA authenticationView AnswerAnswer: A
Which action can the administrator only perform in User view?
A network administrator is managing an HP Comware switch from the CLI. Which action can the administrator only perform in User view?A . verifying connectivity with traceroute or ping toolsB . creating a VLAN and assigning ports to itC . executing display commandsD . viewing files located in flash memoryView...
Which endpoint or endpoints receive broadcast ARP requests sent by EndpointA?
Refer to the exhibit. Which endpoint or endpoints receive broadcast ARP requests sent by EndpointA?A . EndpointB, EndpointC, and EndpointDB . EndpointB onlyC . EendpointB and EndpointC onlyD . EndpointC onlyView AnswerAnswer: D
What is a recommendation for this topology?
Refer to the exhibit. The network administrator is setting up Multiple Spanning Tree Protocol (MSTP) with the settings shown in the exhibit. All the switches are in the same region. The administrator has requested help determining which VLANs each switch-to-switch link should carry. What is a recommendation for this topology?A...
What can a network administrator determine from the output in the exhibit?
Refer to the exhibit. What can a network administrator determine from the output in the exhibit?A . The switch will boot the primary software on its next boot.B . The switch has no software stored in the secondary slot.C . The switch is using the config file in the primary...
What is the effect?
A network administrator enters this command on an HP ProVision switch with IP routing enabled: ip route 0.0.0.0/0 10.1.1.1 metric 10 distance 10 This is the only IP route to 0.0.0.0/0 on the switch. What is the effect?A . The switch uses this route for all traffic that does not...
What is one difference between Network Segment-based discovery and ARP-based discovery on HP Intelligent Management Center (IMC)?
What is one difference between Network Segment-based discovery and ARP-based discovery on HP Intelligent Management Center (IMC)?A . With Network Segment-based discovery, IMC can discover multiple devices. With ARP-based discovery, IMC can only discover one device; the administrator must re-run ARP-based discovery to discover a second device.B . With Network...
