Given this "debug isdn q921" output, what is the problem with the PRI?

Refer the exhibit. Given this "debug isdn q921" output, what is the problem with the PRI?A . Layer 1 is down on the controller.B . PRI does not have an IP address configured on the interface.C . Noting, the PRI is sending keepalives.D . Layer 2 is down on the...

April 23, 2020 No Comments READ MORE +

When a user dials a number with a phone that is registered to the Cisco Unified Communications Manager, what is the default timeout before the number is sent?

When a user dials a number with a phone that is registered to the Cisco Unified Communications Manager, what is the default timeout before the number is sent?A . 3 secondsB . 15 secondsC . 10 secondsD . 5 secondsView AnswerAnswer: B

April 23, 2020 No Comments READ MORE +

What is the only audio codec that can be used for the call?

Refer to the exhibit. Endpoint A calls endpoint B. What is the only audio codec that can be used for the call?A . G277/8000B . PCMA/8000C . Telephone-event/8000D . G7221/16000View AnswerAnswer: A

April 22, 2020 No Comments READ MORE +

Calls are being delivered to the end user in the globalized format. Where does an engineer configure the calling number into a localized format?

Calls are being delivered to the end user in the globalized format. Where does an engineer configure the calling number into a localized format?A . gatewayB . route patternC . IP phoneD . service parametersView AnswerAnswer: A

April 22, 2020 No Comments READ MORE +

Which configuration on the voice mailbox makes this change?

A Cisco Unity Connection Administrator must set a voice mailbox so that is can be accessed form a secondary device. Which configuration on the voice mailbox makes this change?A . Mobile UserB . Alternate NamesC . Attempt Forward routing ruleD . Alternate ExtensionsView AnswerAnswer: D

April 22, 2020 No Comments READ MORE +

Which command in the MGCP gateway configuration defines the secondary Cisco Unified Communications Manager server?

Which command in the MGCP gateway configuration defines the secondary Cisco Unified Communications Manager server?A . ccm-manager redundant-hostB . Mgcp call-agentC . MgcpappD . ccm-manager fallback-mgcpView AnswerAnswer: A

April 22, 2020 No Comments READ MORE +

Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?

Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?A . Set up media ports for each port group to use IPv4.B . Set...

April 21, 2020 No Comments READ MORE +

Which access control group is required on an end user to allow Jabber to do deskphone mode?

Which access control group is required on an end user to allow Jabber to do deskphone mode?A . Standard CTI EnabledB . Standard CTI Allow Reception of SRTP key MaterialC . Allow control of device from CTID . Standard CTI Secure ConnectionView AnswerAnswer: A

April 20, 2020 No Comments READ MORE +

Which two protocols does Cisco IM and Presence use to authenticate Jabber? (Choose two.)

Which two protocols does Cisco IM and Presence use to authenticate Jabber? (Choose two.)A . TCPB . SOAPC . AXLD . XMPPE . QBEView AnswerAnswer: BD

April 20, 2020 No Comments READ MORE +

Which SDP parameter causes this issue?

Refer to the exhibit. A call is failing to establish between two SIP Devices. The Called device answer with this SDP. Which SDP parameter causes this issue?A . The RTP port is set to 0.B . The payload forC . 711ulaw must be 18.D . The media stream is set...

April 20, 2020 No Comments READ MORE +