When designing a large, high-availability wireless network, what changes to a mobility- group would create less load on the controllers while maintaining the same mobility messages?

When designing a large, high-availability wireless network, what changes to a mobility- group would create less load on the controllers while maintaining the same mobility messages?A . remove unnecessary controllers from the mobility-group to cut down on the controller's messaging loadB . separate the controllers into different mobility-groups per controller...

March 13, 2020 No Comments READ MORE +

Which three things do you need to consider prior to performing a wireless site survey? (Choose three.)

Which three things do you need to consider prior to performing a wireless site survey? (Choose three.)A . The time required to acquire any additional infrastructure components.B . The time required to survey each potential AP location.C . The time required to assess application server locations at the customer facility.D...

March 13, 2020 No Comments READ MORE +

What three configuration changes will be most effective to improve performance?

Clients are experiencing artifacts in multicast video even though the network was recently upgraded to 802.11n APs. What three configuration changes will be most effective to improve performance? (Choose three.)A . increase mandatory data rateB . enable 40 MHz wide channelsC . enable Call Admission ControlD . increase QoS marking...

March 13, 2020 No Comments READ MORE +

Which channel must be excluded from the access points RRM calculation to avoid network disruption due to weather radar activity?

A customer is deploying a mesh outdoor wireless network based on FCC standards where spectrum analysis shows significant radar energy propagating throughout the coverage area from a local weather station. Which channel must be excluded from the access points RRM calculation to avoid network disruption due to weather radar activity?A...

March 13, 2020 No Comments READ MORE +

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?A . 10 percentB . 15 percentC . 20 percentD . 25 percentE . Application dependentView AnswerAnswer: E

March 13, 2020 No Comments READ MORE +

What does this indicate about the signal strength?

After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?A . The area is...

March 13, 2020 No Comments READ MORE +

Which three possible configurations reflect the minimum number of APs needed?

An engineer is conducting a location readiness test and wants a selected point to be considered location-ready. Which three possible configurations reflect the minimum number of APs needed? (Choose three.)A . One AP is resident in each quadrant surrounding the point-in-question.B . One AP per 1400 sq. ft. on the...

March 13, 2020 No Comments READ MORE +

Which wireless attribute is added to the floor-level calculation by calibrating the floor?

An engineer would like to calibrate the RF environment to improve accuracy. Which wireless attribute is added to the floor-level calculation by calibrating the floor?A . attenuationB . TX powerC . multipathD . SNRView AnswerAnswer: A

March 12, 2020 No Comments READ MORE +

How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping. How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client...

March 12, 2020 No Comments READ MORE +

How should the controllers be deployed to provide the least number of controllers, the highest redundancy, and the easiest management?

You have a customer that is building a new campus of four 3-story buildings that you have just completed the site survey for. The customer is interested in the mount of rack space they will need to allocate in either the building MDF or in the data center for controllers....

March 12, 2020 No Comments READ MORE +