- All Exams Instant Download
Dynamic trunk negotiation fails between S1 and S2, which cause of the problem is true?
Refer to the exhibit. Dynamic trunk negotiation fails between S1 and S2, which cause of the problem is true?A . there are different VTP domain for S1 and S2B . there is a speed mismatch between S1 and S2C . S1 has a FastEthernet interfaceD . The switchport mode is...
The tunnel fails to come up. which two actions resolve the issue?
Refer to the exhibit. The tunnel fails to come up. which two actions resolve the issue? (choose two)A . On R2, change the tunnel source to 10.1.2.1B . On R1, change the tunnel source to 10.1.1.1C . On R1, change the tunnel destination to 10.1.3.2D . On R2, change the...
What is the solution of the fault condition?
What is the solution of the fault condition?A . Under the interface Serial0/0/0 configuration enter the ip nat inside commandB . Under the interface Serial0/0/1 configuration enter the ip nat outside commandC . Under interface Serial0/0/1 delete the “ip nat inside” command and add the “ip nat outside” commandD ....
Drag drop question about bottom-up troubleshooting method.
Drag drop question about bottom-up troubleshooting method. Following the bottom-up thsoot method, please order from step 1 to step 4 how to solve an issue with an IP phone.View AnswerAnswer:
Which two commands are used to choose uRPF drops?
Which two commands are used to choose uRPF drops?A . show ip interfaceB . show interfaceC . show ip cefD . show ip trafficE . show cef trafficView AnswerAnswer: A D Explanation: With uRPF properly deployed and configured throughout the network infrastructure, administrators can use the show cef interface type...
Drag drop question about bottom-up troubleshooting method.
Drag drop question about bottom-up troubleshooting method. Following the bottom-up thsoot method, please order from step 1 to step 4 how to solve an issue with an IP phone.View AnswerAnswer:
The Fault Condition is related to which technology?
The Fault Condition is related to which technology?A . BGPB . NATC . IP NATD . IPv4 OSPF RoutingE . IPv4 OSPF RedistributionF . IPv6 OSPF RoutingG . IPv4 layer 3 securityView AnswerAnswer: C Explanation: Clients 1 and 2 belong in the 10.2.0.0 subnet, as if you observe the NAT...
Which output is expected in the blank line for the OSPF adjacency process?
Refer to the exhibit. Which output is expected in the blank line for the OSPF adjacency process?A . EXSTARTB . EXCHANGEC . LOADINGD . FULLView AnswerAnswer: A
Please Answer Questions Follow The Prompts Below
BGP sim View AnswerAnswer: R1 configuration Router>enable Router#show running-config show run on R1 can see the following configuration ―-output omitted―- router bgp 64520 network 172.16.1.1 mask 255.255.255.255 neighbor IBGP peer-group neighbor IBGP remote-as 64550 ----wrong AS neighbor IBGP update-source loopback0 neighbor 172.16.2.2 peer-group IBGP neighbor 172.16.3.3 peer-group IBGP neighbor 209.165.200.2...
On which device is the fault condition located?
Ticket 1 OSPF Authentication TROUBLE TICKET STATEMENT: “The implementation group has been using the test bed to do a ‘proof-of-concept’ that required both client 1 and client 2 to access the Web Server at 209.65.200. 241. After several changed to interface status, network addressing, routing schemes and layer 2 connectivity,...
