Which statement about Link Aggregation when implementing on a Cisco Wireless LAN Controller is true?

Which statement about Link Aggregation when implementing on a Cisco Wireless LAN Controller is true?A . The EtherChannel must be configured in “mode active”.B . When enabled, the WLC bandwidth drops to 500 Mbps.C . To pass client traffic, two or more ports must be configured.D . One functional physical...

March 21, 2020 No Comments READ MORE +

What is the result of this configuration?

Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?A . The link becomes an access port.B . The link is in an error disabled state.C . The link is...

March 21, 2020 No Comments READ MORE +

Which IPv6 address type communication between subnets and cannot route on the Internet?

Which IPv6 address type communication between subnets and cannot route on the Internet?A . link-localB . unique localC . multicastD . global unicastView AnswerAnswer: B

March 20, 2020 No Comments READ MORE +

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . activeB . onC . autoD . desirableView AnswerAnswer: B

March 20, 2020 No Comments READ MORE +

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?A . The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.B . The Layer 2 switch sends a copy of a...

March 19, 2020 No Comments READ MORE +

Which result occurs when PortFast is enabled on an interface that is connected to another switch?

Which result occurs when PortFast is enabled on an interface that is connected to another switch?A . Root port choice and spanning tree recalculation are accelerated when a switch link goes down.B . After spanning tree converges, PortFast shuts down any port that receives BPDUs.C . VTP is allowed to...

March 18, 2020 No Comments READ MORE +

Which action do the switches take on the trunk link?

Refer to the exhibit. Which action do the switches take on the trunk link?A . The trunk does not form, and the ports go into an err-disabled status.B . The trunk forms, but the mismatched native VLANs are merged into a single broadcast domain.C . The trunk forms, but VLAN...

March 18, 2020 No Comments READ MORE +

What is the primary effect of the spanning-tree portfast command?

What is the primary effect of the spanning-tree portfast command?A . It immediately enables the port in the listening state.B . It immediately puts the port into the forwarding state when the switch is reloaded.C . It enabled BPDU messages.D . It minimizes spanning-tree convergence time.View AnswerAnswer: D Explanation: Reference:...

March 18, 2020 No Comments READ MORE +

Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?A . PlatinumB . BronzeC . GoldD . SilverView AnswerAnswer: A Explanation: Reference: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81831-qos­wlc-lap.html

March 18, 2020 No Comments READ MORE +

Which usable IP address and subnet mask combination meets this criteria?

An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?A . interface e0/0description to HQ-A370:98968ip address 10.2.1.3 255.255.255.252B . interface e0/0description to HQ-A370:98968ip address 192.168.1.1 255.255.255.248C . interface e0/0description to HQ-A370:98968ip address 172.16.1.4 255.255.255.248D . interface e0/0description to HQ-A370:98968ip...

March 18, 2020 No Comments READ MORE +