Huawei H35-480_V3.0-ENU HCIA-5G-RAN V3.0 Exam Online Training

It looks so much easy to pass the H35-480_V3.0-ENU HCIA-5G-RAN V3.0 Exam exam but the truth is, it is the hardest exam to go through. It requires your dedication, hard work, and most accurate preparation material for the purpose of getting good grades in Huawei H35-480_V3.0-ENU exam. I think aim to get good grades in HCIA-5G-RAN H35-480_V3.0-ENU is the secret of your success, first of all, prepare yourself for it then make a decision from where you have to buy your Huawei H35-480_V3.0-ENU HCIA-5G-RAN V3.0 Exam Online Training and then start work on it and I am 100% sure you will make it with high percentage.

Page 1 of 2

1. Which of the following methods can be used to obtain VLAN IDs after a base station is powered on?

VLAN scanning

Configuration on LMT

Remote DHCP assignment

VLAN detection

2. After the NR base station commissioning is complete and before services go online, which of the following must be set for the NE status?

Normal

New

Upgrade

Testing

3. The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

True

False

4. What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

4T8R

2T2R

2T4R

4T4R

5. What are the typical sizes of ping packets and intervals in single site verification?

1500bytes, 2s

1500 bytes,1s

32 bytes,1s

32 bytes, 2s

6. In NSA networking, which of the following modes is used to anchor 5G NR?

OGSM

WCDMA

CDMA

LTE

7. Which of the following statements about the NR slot structure are correct?

Downlink slots can only be used to transmit downlink data.

Downlink self-contained slots can be used to transmit uplink data and SRSs.

The number of symbols in one slot is fixed to 14 regardless of the subcarrier spacing configuration.

The symbols in a slot can be classified as downlink, uplink, or flexible.

8. The BBU5900 uses a modular design.

Which of the following subsystems constitute the BBU?

Main control subsystem

Transmission subsystem

Baseband subsystem

RF subsystem

9. 5G wireless network cloudification can significantly improve the user rate.

True

False

10. Which of the following statements about the functions of an AAU are correct?

Up/down conversion of spectrum

Power amplification

Signal filtering

Baseband data processing

Analog-to-digital/digital-to-analog conversion

Page 2 of 2

11. C-band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage ― how much does this imbalance approximately amount to?

5dB

3dB

12dB

20dB

12. gNodeBs periodically send TPC commands to UEs over PDCCHs to control the transmit power of which of the following uplink channels or signals of UEs?

SRS

PUSCH

PUCCH

13. The RSRP value of the test terminal can be viewed on the GENEX Probe.

Which of the following test results indicate good signal quality?

30 to 60dBm

-60dBm to -90dBm

0 to 60dBm

-30 to -60dBm

14. On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

True

False

15. In what scenarios is GENEX Assistant typically applied?

Wireless network adjustment

Single site verification

Batch processing of gNodeB alarms

Routine network optimization

16. Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment?

Site deployment list

Data configuration file of the base station

Base station software package of the target version

Base station license

17. An NR CQI value represents a coding scheme and coding efficiency.

How many bits does a CQI value reported by a UE have?

18. In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites.

Which of the following is the requirement of the transmission delay in such case?

<40ms

<10ms

<30ms

<20ms

19. Which of the following factors trigger measurement in connected mode in SA networking?

Periodic TAU

Whether or not the UE is moving

Whether or not neighboring frequencies are configured

Signal quality of the serving cell

20. SSB GSCN is the center frequency number of an NR cell.

True

False

Latest H35-480_V3.0-ENU Dumps Valid Version with 60 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Instant Download H35-480_V3.0-ENU PDF