Based on this output, what is correct?

Examine the AOS-CS switch output: Based on this output, what is correct?A . 802.1X authentication was successful, but MAC authentication is yet to startB . 802.1X authentication occurred and downloadable user roles are deployedC . A local user role was deployed using a ClearPass solutionD . Only 802.1X authentication is...

July 25, 2022 No Comments READ MORE +

What would cause this problem?

An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on...

July 24, 2022 No Comments READ MORE +

Based on this configuration, which statement is correct regarding IoT traffic?

Examine the following AOS-CX configuration: Based on this configuration, which statement is correct regarding IoT traffic?A . If 10.100.1.2 is not reachable, the IoT traffic will be automatically dropped by the switchB . If a specific route is not available in the routing table, the traffic will be routed to...

July 24, 2022 No Comments READ MORE +

What is correct regarding the operation of VSX and multicasting with PIM-SM routing configured?

What is correct regarding the operation of VSX and multicasting with PIM-SM routing configured?A . Each VSX peers runs PIM and builds its own group database. One of the VSX peers is elected as the designated router (DR) to forward multicast streams to a receiver VLANB . Each VSX peers...

July 24, 2022 No Comments READ MORE +

Which solution should the company implement?

A company has an existing wireless solution involving Aruba APs and Mobility controllers running 8.4 code. The solution leverages a third-party AAA solution. The company is replacing existing access switches with AOS-CX 6300 and 6400 switches. The company wants to leverage the same security and firewall policies for both wired...

July 23, 2022 No Comments READ MORE +

action taken by an AOS-CX switch when there is a match on this rule?

An administrator creates an ACL rule with both the “count” and “log” option enabled. What is correct about the action taken by an AOS-CX switch when there is a match on this rule?A . By default, a summarized log is created every minute with a count of the number of...

July 23, 2022 No Comments READ MORE +

Which type of authentication must be configured on an AOS-CX switch ports where both guests and employees connect?

A company requires access by all users, guests, and employees to be authenticated. Employees will be authenticated using 802.1X, whereas guests will be authenticated using captive portal. Which type of authentication must be configured on an AOS-CX switch ports where both guests and employees connect?A . Both 802.1X and captive...

July 23, 2022 No Comments READ MORE +

What should the administrator do to fix this problem?

A network administrator is managing a network that deploys a multicast service. The administrator has multiple streams successfully being routed by PIM-DM in the network. The administrator then adds a new stream with a destination address of 239.0.0.1. However, clients who have not joined the stream are receiving it. What...

July 23, 2022 No Comments READ MORE +

Which example defines how to implement active gateway on the VSX core for VLAN 11?

Examine the attached diagram. The two PCs are located in VLAN 11 (10.1.11.0/24). Which example defines how to implement active gateway on the VSX core for VLAN 11?A . interface vlan 11 active-gateway ip 10.1.11.1 active-gateway mac 02:02:00:00:01:00B . interface lag 254 active-gateway vlan 11 ip 10.1.11.1 active-gateway vlan 11...

July 21, 2022 No Comments READ MORE +

Which option correctly defines how to identify a VLAN as a voice VLAN on an AOS-CX switch?

Which option correctly defines how to identify a VLAN as a voice VLAN on an AOS-CX switch?A . Switch(config)# port-access lldp-group <LLDP-group-name> Switch(config-lldp-group)# vlan <VLAN-ID>B . Switch(config)# port-access role <role-name> Switch(config-pa-role)# vlan access <VLAN-ID>C . Switch(config)# vlan <VLAN-ID> Switch(config-vlan-<VLAN-ID>)# voiceD . Switch(config)# vlan <VLAN-ID> voiceView AnswerAnswer: C

July 21, 2022 No Comments READ MORE +