- All Exams Instant Download
When adding a new member to an existing IRF domain, which of the following must you perform first?
When adding a new member to an existing IRF domain, which of the following must you perform first?A . Define the IRF priority.B . Create the IRF logical port.C . Define the IRF domain name.D . Define the IRF member number.View AnswerAnswer: D
How can the administrator do this?
A network administrator wants to disable physical interfaces 13-24 on an HP ProVision switch. How can the administrator do this?A . Create a named port group for interfaces 13-24. Then disable the named port group.B . Use the interface <ID> disablecommand. Specify 13-24 for the ID . Assign the range...
Which HP solution delivers automated virtual machine orchestrator, automatic synchronization of network connectivity information, and visibility to performance of wired and wireless users?
Which HP solution delivers automated virtual machine orchestrator, automatic synchronization of network connectivity information, and visibility to performance of wired and wireless users?A . Unified Wired-WLAN modules and switchesB . Intelligent Management Center (IMC)C . Virtual Connect FlexFabricD . Intelligent Resilient FrameworkView AnswerAnswer: B Explanation: Reference: http://h17007.www1.hp.com/docs/mark/4AA3-4496ENW.pdf
Which term refers to aggregated links on HP ProVision switches?
Which term refers to aggregated links on HP ProVision switches?A . smart linkingB . meshingC . EtherChannelsD . trunkingView AnswerAnswer: D Explanation: Reference: ProCurve uses the term “Trunk” to describe a group of aggregated links. HP Port Trunking and LACP serve to allow several physical links to operate as one...
Which default setting applies to the ProVision switches?
A customer is implementing a network using HP ProVision switches. Which default setting applies to the ProVision switches?A . All ports are disabled.B . Routing is enabled.C . Telnet is enabled.D . A static IP address is assigned to VLAN 1.View AnswerAnswer: C
What is one step in the configuration of this feature?
An HP Comware switch should send messages to an SNMP server when various events occur. What is one step in the configuration of this feature?A . Enable SSH on the switch, and create a user account to match settings on the SNMP server.B . Set the SNMPv2 read-write community string...
What is a valid reason to choose an 802.11a wireless implementation?
What is a valid reason to choose an 802.11a wireless implementation?A . It supports a large range (distance) from the AP at a given data speedB . It has fewer available channels than 802.11b/g, enabling easier deploymentC . It has transmission speed higher than 802.11nD . It will not interface...
On an HP ProVision switch, what is the corresponding term used for the Pre column in the Comware output shown in the exhibit?
Refer to the exhibit. The exhibit shows partial output of the HP Comware display ip routing-table command. Note the Pre or preference column. On an HP ProVision switch, what is the corresponding term used for the Pre column in the Comware output shown in the exhibit?A . protocol rankingB ....
What correctly describes how an admin user must now log in?
Refer to the exhibit. An HP Comware switch is using its default user-interface settings. The network administrator then enters the commands shown in the exhibit. What correctly describes how an admin user must now log in?A . When the admin user logs in to the console port, the admin user...
What is the correct IRF port ID for member 2?
A company needs a two-member Intelligent Resilient Framework (IRF) virtual switch. The network administrator is configuring IRF member 2 that will connect to port 1/1 on IRF member 1. What is the correct IRF port ID for member 2?A . 1/2B . 2/2C . 1/1D . 2/1View AnswerAnswer: B
