Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued on switch 1 to correct this problem?

The network administrator cannot to switch 1 over a telnet session, although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.

Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued on switch 1 to correct this problem?
A . Switch1(config)# i nterface fa0 /1
Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
B . Switch1 (config)# interface fa0/1
Switch1 (config-if)# switchport mode trunk
C . Switch 1 (config)# i nterface fa0 /1
Switch1 (config-if)# duplex full
Switch1 (config-if)# speed 100
D . Switch1 (config-if)# default-gateway 192.168.24.1
E . Switch1 (config)# line con 0
Switch1(config-line)# password cisco
Switch1 (config-line)#login

Answer: D

Latest 200-125 Dumps Valid Version with 759 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Leave a Reply

Your email address will not be published.

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>