- All Exams Instant Download
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
Refer to exhibits. Exhibit A. Exhibit B. Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits. To correct this traffic shaping issue on FortiGate, what configuration change must be...
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two)
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two)A . Specify outgoing interface routing cost. B. Configure SD-WAN rules interface preference. C. Select SD-WAN balancing strategy. D. Specify incoming interfaces in SD-WAN rules.View AnswerAnswer: B,C
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
Refer to the exhibit. Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?A . The type of traffic defined and allowed on firewall policy ID 1 is UDP. B. FortiGate has terminated the session after a change on policy ID 1. C. Changes have been made on...
Based on the exhibits, which statement is correct?
Refer to exhibits. Exhibit A. . Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members. Based on the exhibits, which statement is correct? A. The dead member interface stays unavailable until an administrator manually brings the interface back. B. The...
Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?
Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?A . diagnose sys virtual-wan-link service B. get router info routing-table C. diagnose debug application ike D. get ipsec tunnel listView AnswerAnswer: C
Which two statements about the debug output are true?
Refer to the exhibit. Which two statements about the debug output are true? (Choose two)A . The debug output shows per-IP shaper values and real-time readings. B. FortiGate provides statistics and reading based on historical traffic logs. C. Traffic being controlled by the traffic shaper is under 100 KB/s. D....
Which two statements are correct if a dynamic site-to-site tunne1 between Toronto and London has been established?
Refer to the exhibit. Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology Which two statements are correct if a dynamic site-to-site tunne1 between Toronto and London has been established? (Choose two) B....
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule?
Refer to the exhibit. Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)A . Set priority 10. B. Set cost 15. C. Set load-balance-mode source-ip-ip-based. D. Set source 100.64.1.1.View...
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?A . FortiGate allocates each IP address a maximum 10 Mbps of bandwidth. B. Each IP is guaranteed a minimum 10 Mbps of bandwidth C. A single user uses the allocated bandwidth divided by...
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two)
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two)A . It creates redundant tunnels between hub-and-spokes, in case failure takes place on theprimary links. B. It dynamically assigns cost and weight between the hub and the spokes, based on the physical...
