- All Exams Instant Download
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?A . C9000 Series B. N-Series C. S-Series D. Z-SeriesView AnswerAnswer: B
On which OSI layers do standard ACL filters operate?
On which OSI layers do standard ACL filters operate?A . 2 and 3 B. 2 and 7 C. 3 and 4 D. 4 and 7View AnswerAnswer: C
Which IPv6 scope is used for private addressing on a local network?
Which IPv6 scope is used for private addressing on a local network?A . Global B. Area wide C. Unique local D. APIPAView AnswerAnswer: C
Which port type should be used for only VLAN-unaware devices?
Which port type should be used for only VLAN-unaware devices?A . Access port B. General port C. Hybrid port D. Trunk portView AnswerAnswer: C
What is the default OSPF “hello interval”?
What is the default OSPF “hello interval”?A . 5 seconds B. 10 seconds C. 15 seconds D. 30 secondsView AnswerAnswer: B
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?A . Store-and-forward B. Fragment-free C. Unicast D. Cut-throughView AnswerAnswer: D
When configuring a switch, which CLI mode only supports limited show commands?
When configuring a switch, which CLI mode only supports limited show commands?A . EXEC B. Maintenance C. Configuration D. EXEC PrivilegeView AnswerAnswer: A Explanation: Reference: https://www.dell.com/support/manuals/us/en/04/poweredge-fx2/dell%20fn%20ioa%20config_9.8.0.0_pub-v1/cli-modes?guid=guid-aeb7d44d-2413-4da8-b8b9-2f8a26bad435&lang=en-us
Which type of domains are connected by a Layer 2 switch?
Which type of domains are connected by a Layer 2 switch?A . Single collision domain and a single broadcast domain B. Multiple broadcast domains and multiple collision domains C. Multiple collision domains and a single broadcast domain D. Single collision domain and multiple broadcast domainsView AnswerAnswer: C
What are Network Address Translation (NAT) inside global addresses?
What are Network Address Translation (NAT) inside global addresses?A . Addresses used by NAT router when sending frames to devices on the local network B. Public IP addresses used by the local network to communicate with the Internet C. Private IP addresses used by the local network D. Pubic addresses...
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator...
