- All Exams Instant Download
What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?
What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?A . All GPU cards must be installed at the same timeB . All GPU cards must be of the same type but can be a different modelC . All GPU cards must be of the same...
Where is the Asset Tag located on the Dell EMC PowerEdge server?
Where is the Asset Tag located on the Dell EMC PowerEdge server?A . Server chassisB . BIOS settingsC . Dell manufacturing labelD . Pull-out information tabView AnswerAnswer: B
What happens when the Hardware Root of Trust fails to validate the BIOS?
What happens when the Hardware Root of Trust fails to validate the BIOS?A . Boot Guard switches over to the backup BIOS and logs a warning in the system event log.B . Automated BIOS Recovery process recovers the BIOS from the DUP saved in the control panel.C . The server...
How should they configure the server and deploy the OS?
A technician is installing Windows Server 2016 on a server with RAID 1 and RAID 5 virtual disks. How should they configure the server and deploy the OS?A . Go to system setup to configure both virtual disks Select the Deploy OS option in the system setup utilityB . Go...
What should the technician do?
One of the servers in a datacenter is set to use the 1+1 power redundancy option with a hot spare. The server uses 1100W PSUs. An SNMP trap has been sent alerting the technician to a PSU failure. Since this is the "hot spare" PSU, the technician chooses an available,...
What is the minimum iDRAC license required to perform this task?
A technician needs to install the OS on a server remotely using iDRAC. What is the minimum iDRAC license required to perform this task?A . ExpressB . EnterpriseC . BasicD . Baseboard Management ControllerView AnswerAnswer: B
What should the technician do to achieve the desired RAID level?
A technician is tasked to perform a RAID Level Migration (RLM) of a RAID 5 array to a RAID 6 array. They back up data and look in iDRAC Storage and find that the current RAID 5 array is sliced into two virtual disks. What should the technician do to...
Which three steps must a technician take prior to replacing a server component with blue tabs/release? (Choose three.)
Which three steps must a technician take prior to replacing a server component with blue tabs/release? (Choose three.)A . Powers off the serverB . Apply anti-static proceduresC . Hot-swap the componentD . Put the server into maintenance modeE . Remove power cablesView AnswerAnswer: CDE
Where is the data stored to allow Easy Restore to successfully complete a system board replacement?
Where is the data stored to allow Easy Restore to successfully complete a system board replacement?A . NAND Flash module on the disk drive mid planeB . IDSDM SD cardC . vFlash SD cardD . Serial Flash storage in the server’s front panelView AnswerAnswer: C
Which export type in iDRAC restores a Server Configuration Profile to a known baseline?
Which export type in iDRAC restores a Server Configuration Profile to a known baseline?A . AdvancedB . ReplacementC . BasicD . CloneView AnswerAnswer: B
