- All Exams Instant Download
Which configuration must an engineer apply to the two PE routers so that they validate reverse packet forwarding for packets entering their Gi2 interfaces and drop traffic from the RFC1918 space?
Refer to the exhibit. The CE router is peering with both PE routers and advertising a public prefix to the internet. Routing to and from this prefix will be asymmetric under certain network conditions, but packets must not be discarded. Which configuration must an engineer apply to the two PE...
Which result should the operator expect when trying to ping to an XR1 local address?
Refer to the exhibit. While troubleshooting the network, a network operator with an employee id: 3812:12:993 is trying to ping XR1. Which result should the operator expect when trying to ping to an XR1 local address?A . ICMP traffic works at a policed rate of 19 bytes per second every...
Which configuration must the administrator deploy on GW1 to permit IGMP Joins only to the assigned (S, G) feed?
Refer to the exhibit. A network administrator is implementing IGMP to enable multicast feed transmission to the receiver. Which configuration must the administrator deploy on GW1 to permit IGMP Joins only to the assigned (S, G) feed? A) B) C) D) A . Option A B. Option B C. Option...
How is routing information distributed on such a network?
A network administrator is planning a new network with a segment-routing architecture using a distributed control plane. How is routing information distributed on such a network?A . Each segment is signaled by a compatible routing protocol, and each segment makes its own steering decisions based on SR policy. B. Each...
How does Cisco MPLS TE use OSPF extensions to allow for optimized transit between a headend router and a destination router?
How does Cisco MPLS TE use OSPF extensions to allow for optimized transit between a headend router and a destination router?A . Router LSAs share router link advertisements to each router within the MPLS environment so that tunnels can be built bidirectionally. B. ASBR Summary LSAs share OSPF domain information...
Which two features will be used when defining SR-TE explicit path hops if the devices are using IP unnumbered interfaces? (Choose two.)
Which two features will be used when defining SR-TE explicit path hops if the devices are using IP unnumbered interfaces? (Choose two.)A . router ID B. labels C. node address D. next hop address E. output interfaceView AnswerAnswer: B,C
Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?
Refer to the exhibit. A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?A . Configure MPLS LDP IGP synchronization on the...
Why do packet loops occur during the configuration of BlDlR-PIM?
Why do packet loops occur during the configuration of BlDlR-PIM?A . The network does not support BIDIR-PIM B. The network is partially upgraded to support BIDlR-PIM C. No interface for carrying traffic for multicast groups has been configured D. The router has not been configured to advertise itselfView AnswerAnswer: B
Drag and drop the descriptions from the left onto the corresponding OS types on the right
DRAG DROP Drag and drop the descriptions from the left onto the corresponding OS types on the right. View AnswerAnswer: Explanation: IOS XE: It uses linux-based kernel It has a separate control plane IOS: It is monolithic It shares memory space
Which statement al about this configuration is true?
Refer to the exhibit: An engineer is preparing to implement link aggregation configuration. Which statement al about this configuration is true?A . The switch port actively sends packets to negotiate an EtherChannel using PAgP B. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an...
