- All Exams Instant Download
Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?A . wlcbostname.domain.com B. cisco-capwap-controller.domain.com C. ap-manager.domain.com D. primary-wlc.domain.comView AnswerAnswer: B Explanation: DNS: If you have configured your DHCP server to provide both...
What is the cause of the log messages?
Refer to me exhibit. What is the cause of the log messages?A . hello packet mismatch B. OSPF area change C. MTU mismatch D. IP address mismatchView AnswerAnswer: B
Which action should the engineer take to resolve this issue?
Refer to the exhibit. An engineer implemented several configuration changes and receives the logging message on switch1. Which action should the engineer take to resolve this issue?A . Change the VTP domain to match on both switches B. Change Switch2 to switch port mode dynamic auto C. Change Switch1 to...
Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?
Refer to the exhibit. Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?A . ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20...
What does the status show?
Refer to the exhibit. After configurating an IPsec VPN, an engineer enters the show command to verify the ISAKMP SA status. What does the status show?A . ISAKMP SA is authenticated and can be used for Quick Mode. B. Peers have exchanged keys, but ISAKMP SA remains unauthenticated. C. VPN...
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?A . switch fabric B. VTEP C. VNID D. host switchView AnswerAnswer: C Explanation: VXLAN uses an 8-byte VXLAN header that consists of a 24-bit VNID and a few reserved bits. The VXLAN header together with the original...
Which interface or interface or interface are able to establish OSPF adjacency?
Refer to the exhibit. A network engineer configures OSPF and reviews the router configuration. Which interface or interface or interface are able to establish OSPF adjacency?A . GigabitEthemet0/1 and GigabitEthernet0/1.40 B. only GigabitEthernet0/1 C. only GigabttEthernet0/0 D. Gigabit Ethernet0/0 and GigabitEthemet0/1View AnswerAnswer: C
Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?
Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?A . ip access-list extended 10 deny tcp host 10.10.10.1 any eq 80 permit ip any any B. ip access-list extended 200 deny tcp...
Which command accomplish this task?
Refer to the exhibit. An engineer must deny Telnet traffic from the loopback interface of router R3 to the loopback interface of router R2 during the weekend hours. All other traffic between the loopback interfaces of routers R3 and R2 must be allowed at all times. Which command accomplish this...
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switch B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14. C. SPAN...
