Cisco 352-001 Cisco Certified Design Expert Qualification Exam Online Training
Cisco 352-001 Online Training
The questions for 352-001 were last updated at Oct 23,2025.
- Exam Code: 352-001
- Exam Name: Cisco Certified Design Expert Qualification Exam
- Certification Provider: Cisco
- Latest update: Oct 23,2025
As part of a new network design documentation, you are required to explain the reason for choosing cisco FabricPath for Layer 2 loop avoidance.
Which two elements help Cisco FabricPath mitigate Layer 2 loops if they happen in the Layer 2 MP network? (Choose two)
- A . MAC tunneling
- B . IS-IS multipath
- C . RPF check
- D . TTL header
Which of the following design options meet the requirement to provide IPv6 interdomain multicast?
- A . MSDP
- B . PIM dense mode
- C . Auto-RP
- D . PIM SSM
CORRECT TEXT
What best describes the difference between Automation and orchestration?

- A . Option A
- B . Option B
- C . Option C
- D . Option D
Which three IS-IS design considerations must be considered when connecting two Layer 3 switches directly using a 10 GBASE C T cabling and forming IS-IS neighbor adjacency? (Choose three)
- A . The area, levels, and interface MTU parameters must match, and system MTU must be unique foe two IS-IS routers to become adjacent
- B . A DlS is elected between the IS-IS neighbors and the elected DIS is pre-empted if a router with a higher system ID is connected
- C . Faster IS-IS hello and dead timers increase bandwidth and CPU use, and may cause instability
- D . A DIS is elected between the IS-IS neighbors and the elected DIS is preempted if a router with a tower system ID is connected
- E . The hello and dead timers must match for two IS-IS routers to become adjacent
- F . The default IS-IS network type is port-to-point so a DIS is not elected
- G . The IS-IS hello and dead timers should be tuned to detect failures as quickly as possible
Which statement about hot-potato routing architecture design is true?
- A . Hot-potato routing is the preferred architecture when connecting to content providers
- B . Hop-potato keeps traffic under the control of the network administrator for longer
- C . OSPF uses hot-potato routing if all ASBRs use the same value for the external metric
- D . Hot-potato routing is prone to misconfiguration as well as poor coordination between two networks
Refer to the exhibit.

You are asked to design the network to converge within 60 ms for unicast packets after a link failure. Native IPv4 forwarding is used and the forwarding plane may not be altered.
Which technology can be enabled while conforming to the design requirements?
- A . IGP neighbor timer tuning
- B . LFA
- C . SPF timer tuning
- D . Cisco MPLS TE/FRR
which technology supports Multi Chassis EtherChannel in the design of a network?
- A . StackWise
- B . vPV
- C . REP
- D . VSS
Which two reasons for implementing Cisco MPLS TE in service provider MPLS backbone are valid? (Choose two.)
- A . When Cisco MPLS TE is required to reroute traffic within less than 1 second in case of a link failure inside the backbone
- B . When Cisco MPLS TE is required to create backup paths independently from the IGP
- C . When Cisco MPLS TE is required to route different MPLS QoS service classes through different paths
- D . When Cisco MPLS TE is a prerequisite for implementing RSVP in the backbone
- E . When Cisco MPLS TE can detect and react to neighbor failures faster than IGPs can
Your company utilizes many types of network transports, and you want to increase the efficiency of the network.
Which solution can be used to improve network efficiency over PPPoE, IPsec and GRE networks?
- A . OTAM
- B . IRDP
- C . Host Discovery Protocol
- D . PMTUD
As part of the security protocol for your network design, you have designated that operator 82 is enabled for DHCP snooping. When option 82 is enabled, which information will be added to the DHCP request?
- A . remote ID and circuit ID
- B . switch IP address and VLAN, module and poet
- C . switch MAC address and switch IP address
- D . switch MAC address and VLAN module and port
