Cisco 350-401 Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) Online Training
Cisco 350-401 Online Training
The questions for 350-401 were last updated at Sep 14,2025.
- Exam Code: 350-401
- Exam Name: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR)
- Certification Provider: Cisco
- Latest update: Sep 14,2025
Refer to the Exhibit.
What is the cause of the log messages?
- A . hello packet mismatch
- B . OSPF area change
- C . MTU mismatch
- D . IP address mismatch
What is the function of a VTEP in VXLAN?
- A . provide the routing underlay and overlay for VXLAN headers
- B . dynamically discover the location of end hosts in a VXLAN fabric
- C . encapsulate and de-encapsulate traffic into and out of the VXLAN fabric
- D . statically point to end host locations of the VXLAN fabric
An engineer is concerned with the deployment of new application that is sensitive to inter-packet delay variance.
Which command configures the router to be the destination of jitter measurements?
- A . Router(config)# ip sla responder udp-connect 172.29.139.134 5000
- B . Router(config)# ip sla responder tcp-connect 172.29.139.134 5000
- C . Router(config)# ip sla responder udp-echo 172.29.139.134 5000
- D . Router(config)# ip sla responder tcp-echo 172.29.139.134 5000
Which method creates an EEM applet policy that is registered with EEM and runs on demand or manually?
- A . event manager applet ondemand
event register
action 1.0 syslog priority critical msg ‘This is a message from ondemand’ - B . event manager applet ondemand
event manual
action 1.0 syslog priority critical msg ‘This is a message from ondemand’ - C . event manager applet ondemand
event none
action 1.0 syslog priority critical msg ‘This is a message from ondemand’ - D . event manager applet ondemand
action 1.0 syslog priority critical msg ‘This is a message from ondemand’
Refer to the Exhibit.
Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two)
- A . R1#network 192.168.0.0 mask 255.255.0.0
- B . R2#no network 10.0.0.0 255.255.255.0
- C . R2#network 192.168.0.0 mask 255.255.0.0
- D . R2#network 209.165.201.0 mask 255.255.192.0
- E . R1#no network 10.0.0.0 255.255.255.0
Which TCP setting is tuned to minimize the risk of fragmentation on a GRE/IP tunnel?
- A . MTU
- B . Window size
- C . MRU
- D . MSS
What is a benefit of data modeling languages like YANG?
- A . They enable programmers to change or write their own application within the device operating system.
- B . They create more secure and efficient SNMP OIDs.
- C . They make the CLI simpler and more efficient.
- D . They provide a standardized data structure, which results in configuration scalability and consistency.
Refer to exhibit.
VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server.
Which command ensures that SW3 receives frames only from VLAN 50?
- A . SW1 (config)#vtp pruning
- B . SW3(config)#vtp mode transparent
- C . SW2(config)=vtp pruning
- D . SW1 (config >»vtp mode transparent
Refer to the Exhibit.
What does the error message relay to the administrator who is trying to configure a Cisco IOS device?
- A . A NETCONF request was made for a data model that does not exist.
- B . The device received a valid NETCONF request and serviced it without error.
- C . A NETCONF message with valid content based on the YANG data models was made, but the request failed.
- D . The NETCONF running datastore is currently locked.
Which LISP component is required for a LISP site to communicate with a non-LISP site?
- A . ETR
- B . ITR
- C . Proxy ETR
- D . Proxy ITR
Latest 350-401 Dumps Valid Version with 404 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
Question 91 has a wrong answer marked s correct. The answer is B.
BPDU filter is the only option to block BPDUs while not going inte err disabled when a BPDU is received.
https://www.exam4training.com/which-command-set-must-be-configured-on-switch1-to-achieve-the-following-results-on-port-fa0-1/
https://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/trash/swstpopt.html#:~:text=The%20BPDU%20filtering%20feature%20can,bpdufilter%20default%20global%20configuration%20command.