156-835 Check Point Certified Maestro Expert exam is a hot Check Point certification exam, Exam4Training offers you the latest free online 156-835 dumps to practice. You can get online training in the following questions, all these questions are verified by Check Point experts. If this exam changed, we will share new update questions.
What is the purpose of g_tcpdump command?
A . Collects traffic dump from Sync network
B. The same as tcpdump, just on Scalable Platform
C. Collects traffic dump from CIN network
D. Collects traffic dump from all Active Appliances within Security Group
Answer: D
What is the minimal amount of cables needed in order to connect an Appliance to an Orchestrator?
A . Three cables: uplink, downlink, SYNC
B. One Downlink cable only
C. Two cables: one uplink and one downlink
D. Four cables: uplink, downlink, SYNC and Management
Answer: B
What is the purpose of g_tcpdump command?
A . Collects traffic dump from Sync network
B. The same as tcpdump, just on Scalable Platform
C. Collects traffic dump from CIN network
D. Collects traffic dump from all Active Appliances within Security Group
Answer: D
Browse to the Orchestrator’s WebUI
A . 3-4-2-6-5-7-1
B. 3-1-7-2-4-6-5
C. 1-4-2-5-7-3-6
D. 7-4-2-5-3-1-6
Answer: A
What is the maximum amount of Appliances within Security group in Dual-Site configuration?
A . 16
B. 15
C. 28
D. 31
Answer: C
What is the purpose of g_tcpdump command?
A . Collects traffic dump from Sync network
B. The same as tcpdump, just on Scalable Platform
C. Collects traffic dump from CIN network
D. Collects traffic dump from all Active Appliances within Security Group
Answer: D
Which is a valid requirement for a supported Maestro appliance?
A . 10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support
B. At least one 10GBps line card
C. Nothing special as Maestro supports any Check Point appliance
D. Line card with double-VLAN and LLDP support
Answer: A
What type of cluster can a Security Group can be compared to?
A . VSLS
B. Load Sharing Active /Active
C. Active / Backup
D. Active / Standby
Answer: B
What is the purpose of g_tcpdump command?
A . Collects traffic dump from Sync network
B. The same as tcpdump, just on Scalable Platform
C. Collects traffic dump from CIN network
D. Collects traffic dump from all Active Appliances within Security Group
Answer: D
There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks.
Assuming there’s no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?
A . 66%/33%
B. 100%/0%
C. 50%/50%
D. 33%/66%
Answer: C