BICSI RCDDv14 BICSI Registered Communications Distribution Designer – RCDDv14 Online Training
BICSI RCDDv14 Online Training
The questions for RCDDv14 were last updated at May 08,2025.
- Exam Code: RCDDv14
- Exam Name: BICSI Registered Communications Distribution Designer – RCDDv14
- Certification Provider: BICSI
- Latest update: May 08,2025
When preparing an upfront cost estimate, the ICT distribution designer MUST consider which two of the following fees? (Select two options.)
- A . Taxes
- B . Permits
- C . Inspection
- D . Licensing
- E . Safety
An ICT distribution designer is reviewing design documents with the owner to gam approval for an ER design.
Which of the following information about the site shall be included?
- A . Sustainability requirements
- B . Suitability requirements
- C . Access and/or service provider requirements
- D . Designer requirements
Which two of the following are ADVANTAGES of underground conduit systems? (Select two options.)
- A . Provide additional physical cable protection
- B . Not adaptable for future facility placement or removal without disturbing the property
- C . Economical over a long life
- D . Require more installation time than aerial or direct-buried installations
- E . Route planning is not as critical as aerial or direct-burial
What is the OPTIMAL lime in the construction process for ICT submittals to be reviewed by the ICT distribution designer?
- A . After the contract is awarded and before project close out
- B . As part of the contract bid process to prevent project delays
- C . Before the contract is awarded
- D . At the beginning of the close out process
What is the MAXIMUM number of work areas served by a single Multiuser Telecommunications Outlet Assembly (MUTOA)?
- A . 5
- B . 10
- C . 12
- D . 18
Telecommunications systems typically combine multiple digital data streams into one data stream.
What is this process called?
- A . Time division multiplexing (TDM)
- B . Wave division multiplexing (WDM)
- C . Coarse wave time division multiplexing (CWTDM)
- D . Coarse wave division multiplexing (CWDM)
The transfer of unwanted signals may occur over one path or several paths.
What method addresses the mitigation or suppression of unwanted signals?
- A . Mounting heights in racks and cabinets
- B . Bonding and grounding
- C . Signal coupling
- D . The use of unshielded cables
A project’s closeout plan will be executed by the project manager (PM) and will be managed and approved by the
- A . owner
- B . contractor
- C . lCT distribution designer
- D . projects installation supervisor
In a PON deployment, which active device is installed at the work area?
Wireless access point
- A . Optical amplifier
- B . Optical line terminal
- C . Optical network terminal
- D . Splitter
When planning a telecommunication termination area, what is the estimated space needed to terminate 144 strands of optical fiber?
- A . 6350.01 mm2 (250 in2)
- B . 7315.21 mm2 (288 in2)
- C . 8890.01 mm2 (350 in2)
- D . 10972.82 mm2 (432 a)
- E . 14376.43 mm2 (566 in2)
Latest RCDDv14 Dumps Valid Version with 288 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
