Based on the setup shown in the exhibit, which IP configuration does the controller need?

Refer to the exhibit.

In Aruba architect plans to design a network for a school with a single controller. Wired clients and APs on each floor are mapped to different VLANs. The VLAN mapping is shown in the exhibit. Dot1x authentication is enabled for all the wireless clients, except guests, staff, and student users are mapped to VLAN 200 and 201, respectively. Controller up-link and all other inter switch links are trunk links and allow all necessary VLANs. APs and wired clients are able to get the IP address and other necessary IP parameters. The core switch is doing the inter VLAN routing for the network.

Based on the setup shown in the exhibit, which IP configuration does the controller need? (Choose two.)
A . RADIUS source interface
B . IP helper address only on virtual interfaces of VLAN 200 and VLAN 201
C . Virtual interfaces for all VLAN 101.102.103.200 and 201.
D . IP helper address on all virtual interfaces of VLAN 101, 102, 103, 200 and 201.
E . Static route to reach the Data Center.

Answer: AB