Enjoy 15% Discount With Coupon 15off

Monthly Archives - December 2022

When an injection point circuit for the purpose of inspection is designated, the recommended up stream limit of the injection point circuit shall be the greater of ?

When an injection point circuit for the purpose of inspection is designated, the recommended up stream limit of the injection point circuit shall be the greater of ?A . minimum 12 inches B. maximum 12 inches C. three pipe diameters D. both A and CView AnswerAnswer: D

Read more...

Which solution includes pre-built APIs, connectors ,implementation templates, and a prescriptive end-to-end reference architecture to enable EHR connectivity and power a patient 360 from any HER into HC using HL7 V2 or FHIR standards?

Which solution includes pre-built APIs, connectors ,implementation templates, and a prescriptive end-to-end reference architecture to enable EHR connectivity and power a patient 360 from any HER into HC using HL7 V2 or FHIR standards?A . Mulesoft Accelerator for HealthCare B. Shield C. Specialty vendors D. Tableau CRM for HealthCareView AnswerAnswer:...

Read more...

A company’s decision to charge different prices for the same service sold in different market segments is most likely based on which of the following metrics?

A company’s decision to charge different prices for the same service sold in different market segments is most likely based on which of the following metrics?A . Internal rate of return (IRR) B. Lifetime customer value (LCV) C. Net present value (NPV) D. Return on investment (ROI)View AnswerAnswer: B

Read more...

What should you consider as best practices when designing BPMN process models? Note: There are 2 correct answers to this question.

What should you consider as best practices when designing BPMN process models? Note: There are 2 correct answers to this question.A . Use, wherever possible, the same message trigger for multiple processes. B. Create a sub-process, when a group of steps can be reused by multiple processes. C. Use parallel...

Read more...