When a wired client connects to an edge switch in an SDA fabric, which component decides whether the client has access to the network?A . control-plane nodeB . Identity Service EngineC . RADIUS serverD . edge nodeView AnswerAnswer: B
Authentication fails for certain users after configuring the joining of the server-side SteelHead appliance to the domain as a read-only domain controller (RODC). What is the most likely issue?A . The users have local branch file serversB . There is an incorrect Short Domain Name (NETBIOS name)C . There’s an...
Which statement about IPv6RAGuardistrue?A . It does not offer protection in environments where IPv6 traffic is tunneledB . It cannot be configured on a switchport interface in the ingress direction.C . Packets that are dropped byIPv6RA Guard cannot be spanned.D . It is not supported in hardware when TCAM is...
What allows endpoints behind a NAT to discover the paths through which they will pass media?A . RTPB . TLSC . SNMPD . ICEView AnswerAnswer: D Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/solutions/PA/ICE/icepa125.html
Which action prevent toll fraud in Cisco Unified Communications Manager?A . Configure ad hoc conference restriction.B . Implement toll fraud restriction in the Cisco IOS router.C . Allow off-net to off-net transfers.D . Implement route patterns in Cisco Unified CView AnswerAnswer: A
You need to configure the MFA settings for users who connect from the Boston office. The solution must meet the authentication requirements and the access requirements. What should you configure?A . named locations that have a private IP address rangeB . named locations that have a public IP address rangeC...
A collaboration engineer must configure Cisco Unified Border Element to support up to five concurrent outbound calls across an Ethernet Link with a bandwidth of 160 kb to the Internet Telephony service provider. Which set of commands allows the engineer to complete the task without compromising voice quality?A . dial-peer...
You have a Windows server that negotiates SMB3 encryption with the client. If you enable SMB3 optimization, but do not configure signing on the SteelHead, will there be any latency optimization?A . Yes, but you won’t have SDR/LZB . Yes, and you still have SDR/LZC . No, but will still...
HOTSPOT You have the application architecture shown in the following exhibit. Use the drop-down menus to select choice that completes each statement based on the information presented in the graphic. NOTE: Each correct selection is worth one point. View AnswerAnswer: Explanation: References: https://docs.microsoft.com/en-us/azure/traffic-manager/traffic-manager-routing-methods https://docs.microsoft.com/en-us/azure/traffic-manager/traffic-manager-monitoring
You are designing a microservices architecture that will be hosted in an Azure Kubernetes Service (AKS) cluster. Apps that will consume the microservices will be hosted on Azure virtual machines. The virtual machines and the AKS cluster will reside on the same virtual network. You need to design a solution...
