Exam4Training

Why?

The "Protection Source when in Combined Mode" settings are configured for a virtual machine as in the exhibit. You would like to enable Application Control on this virtual machine, but there is no corresponding setting displayed.

Why?

A . In the example displayed in the exhibit, no activation code was entered for Application Control. Since the Protection Module is not licensed, the corresponding settings are not displayed.
B. These settings are used when both an host-based agent and agentless protection are available for the virtual machine. Since Application Control is not supported in agentless installations, there is no need for the setting.
C. In the example displayed in the exhibit, the Application Control Protection Module has not yet been enabled. Once it is enabled for this virtual machine, the corresponding settings are displayed.
D. In the example displayed in the exhibit, the VMware Guest Introspection Service has not yet been installed. This service is required to enable Application Control in agentless installations.

Answer: B

Exit mobile version