Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?

Refer to the exhibit.

Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?
A . Configure the access mode for the switch port.
B . Delete VLAN 40.
C . Shut down the relevant interface.
D . Remove the current access VLAN configuration.
E . Enter it into the relevant interface.

Answer: A D E

Explanation:

Configure the access mode for the switch port (A):

This involves setting the switch port to operate in access mode.

Remove the current access VLAN configuration (D): Before changing the VLAN, the current configuration must be cleared.

Enter it into the relevant interface (E): Apply the new configuration to the specific interface, Eth1/10.

Steps:

interface Ethernet 1/10

no switchport access vlan <current VLAN> (Remove current VLAN)

switchport mode access

switchport access vlan 40

References:

Dell Technologies SONiC documentation

Dell Networking Configuration Guide