Exam4Training

Which commands must be added to complete the configuration?

Refer to the exhibit.

An engineer must configure an ERSPAN session with the remote end of the session 10.10.0.1 .

Which commands must be added to complete the configuration?

A)

B)

C)

D)

A . Option A
B . Option B
C . Option C
D . Option D

Answer: A

Explanation:

Example: Configuring an ERSPAN Source Session on a WAN Interface

The following example shows how to configure more than one WAN interface in a single ERSPAN source monitor session. Multiple interfaces have been separated by a commas. monitor session 100 type erspan-source source interface Serial 0/1/0:0, Serial 0/1/0:6

Example: Configuring an ERSPAN Destination Session

The following example shows how to configure an ERSPAN destination session:

monitor session 2 type erspan-destination

destination interface GigabitEthernet1/3/2

destination interface GigabitEthernet2/2/0

source

erspan-id 100

ip address 10.10.0.1

Latest 350-401 Dumps Valid Version with 404 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Exit mobile version