Exam4Training

Which command set must be configured on switch1 to achieve the following results on port fa0/1?

Refer to the Exhibit.

Rapid PVST+ is enabled on all switches.

Which command set must be configured on switch1 to achieve the following results on port fa0/1?

✑ When a device is connected, the port transitions immediately to a forwarding state.

✑ The interface should not send or receive BPDUs.

✑ If a BPDU is received, it continues operating normally.
A . Switch1(config)# spanning-tree portfast bpdufilter default
Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast
B . Switch1(config)# spanning-tree portfast bpduguard default
Switch 1 (config)# interface f0/1
Switch1 (config-if)# spanning-tree portfast
C . Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast
D . Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast
Switch1 (config-if)# spanning-tree bpduguard enable

Answer: D

Latest 350-401 Dumps Valid Version with 404 Q&As

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund

Exit mobile version