Given the interfaces shown in the exhibit. which two statements are true?

Refer to the exhibit. Given the interfaces shown in the exhibit. which two statements are true? (Choose two.)A . Traffic between port2 and port2-vlan1 is allowed by default.B . port1-vlan10 and port2-vlan10 are part of the same broadcast domain.C . port1 is a native VLAN.D . port1-vlan and port2-vlan1 can...

November 16, 2023 No Comments READ MORE +

Which two statements are true about the RPF check? (Choose two.)

Which two statements are true about the RPF check? (Choose two.)A . The RPF check is run on the first sent packet of any new session.B . The RPF check is run on the first reply packet of any new session.C . The RPF check is run on the first...

November 16, 2023 No Comments READ MORE +

When configuring a firewall virtual wire pair policy, which following statement is true?

When configuring a firewall virtual wire pair policy, which following statement is true?A . Any number of virtual wire pairs can be included, as long as the policy traffic direction is the same.B . Only a single virtual wire pair can be included in each policy.C . Any number of...

November 16, 2023 No Comments READ MORE +

What is the default behavior when the local disk is full?

You have enabled logging on your FortiGate device for Event logs and all Security logs, and you have set up logging to use the FortiGate local disk. What is the default behavior when the local disk is full?A . Logs are overwritten and the only warning is issued when log...

November 16, 2023 No Comments READ MORE +

Which two statements ate true about the Security Fabric rating? (Choose two.)

Which two statements ate true about the Security Fabric rating? (Choose two.)A . It provides executive summaries of the four largest areas of security focus.B . Many of the security issues can be fixed immediately by clicking Apply where available.C . The Security Fabric rating must be run on the...

November 16, 2023 No Comments READ MORE +

Given the security fabric topology shown in the exhibit, which two statements are true?

Refer to the exhibit. Given the security fabric topology shown in the exhibit, which two statements are true? (Choose two.)A . There are five devices that are part of the security fabric.B . Device detection is disabled on all FortiGate devices.C . This security fabric topology is a logical topology...

November 16, 2023 No Comments READ MORE +

Which two statements are true?

Refer to the exhibit. The exhibit displays the output of the CLI command: diagnose sys ha dump-by vcluster. Which two statements are true? (Choose two.)A . FortiGate SN FGVM010000065036 HA uptime has been reset.B . FortiGate devices are not in sync because one device is down.C . FortiGate SN FGVM010000064692...

November 15, 2023 No Comments READ MORE +

Which statement is true about the session diagnostic output?

Refer to the exhibit. Which contains a session diagnostic output. Which statement is true about the session diagnostic output?A . The session is in SYN_SENT state.B . The session is in FIN_ACK state.C . The session is in FTN_WAIT state.D . The session is in ESTABLISHED state.View AnswerAnswer: A Explanation:...

November 14, 2023 No Comments READ MORE +

Which statement is correct If option 5 was used with the IPS diagnostic command and the outcome was a decrease in the CPU usage?

Refer to the exhibit. Examine the intrusion prevention system (IPS) diagnostic command. Which statement is correct If option 5 was used with the IPS diagnostic command and the outcome was a decrease in the CPU usage?A . The IPS engine was inspecting high volume of traffic.B . The IPS engine...

November 14, 2023 No Comments READ MORE +

Which IP address will be used to source NAT the internet traffic coming from a workstation with the IP address 10.0.1.10?

Refer to the exhibit. The exhibit contains a network diagram, virtual IP, IP pool, and firewall policies configuration. The WAN (port1) interface has the IP address 10.200. 1. 1/24. The LAN (port3) interface has the IP address 10 .0.1.254. /24. The first firewall policy has NAT enabled using IP Pool....

November 14, 2023 No Comments READ MORE +