Which option correctly describes a WAN network?

Which option correctly describes a WAN network?A . a group of computer resources that communicates between geographically separate locationB . the connection between two separate buildings in the same campusC . a network of devices over long distances but limited to within a single ISPD . compute resources that are...

September 29, 2023 No Comments READ MORE +

What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?

What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?A . Better Core router performance by offloading processingB . Shifting endpoint access to the Aggregation layer from the Access layerC . Using access control lists (ACLs) at the Core to improve performanceD . Connecting WAN/MPLS...

September 28, 2023 No Comments READ MORE +

What command should be used to enable terminal output line by line or page by page?

Refer to the exhibit. The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?A . The command pageB . The command terminal length 30C . The command moreD . The command...

September 28, 2023 No Comments READ MORE +

What is the default password that is required for the admin account while under the Service OS console?

ServiceOS login: admin SVOS> password Enter password: ******** Confirm password: ******** The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above. What is the default password that is required...

September 28, 2023 No Comments READ MORE +

Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?

Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?A . UDP 1812 and UDP 1813B . UDP 161C . TCP 443D . UDP 162View AnswerAnswer: B

September 28, 2023 No Comments READ MORE +

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)A . Management interface split detectionB . Peer switch-based detectionC . Loopback keepalivesD . ARP-basedE . BFDView AnswerAnswer: A,D

September 27, 2023 No Comments READ MORE +

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch. What command could you have issued before making changes that would have recovered the original...

September 26, 2023 No Comments READ MORE +

Which configuration will correct the issue?

Refer to the exhibit. Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN. Which configuration will correct the issue?A . Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181B . Core-1(config)# ip route...

September 25, 2023 No Comments READ MORE +

Which two statements are true regarding Checkpoints on Aruba switches? (Choose two.)

Which two statements are true regarding Checkpoints on Aruba switches? (Choose two.)A . Rolling back to a prior checkpoint triggers a reboot of the switch.B . Stacking switches using VSF or VSX will disable the Checkpoint feature.C . A checkpoint is a snapshot of the running-configuration and relevant metadata at...

September 24, 2023 No Comments READ MORE +

What is Deep Packet Inspection?

What is Deep Packet Inspection?A . a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assignB . a concept that applies to firewalls, when examining packets only up through Layer 4C . a function of Policy Based Routing that examines the...

September 24, 2023 No Comments READ MORE +