You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?

You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers? Solution: The wait to restore timer (WTR) Is set in units of minutes; you can set it to prevent frequent topology changes due to a link going up and down.A ....

September 1, 2021 No Comments READ MORE +

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?

Refer to the exhibit. Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded? Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding...

August 31, 2021 No Comments READ MORE +

Does this correctly describethe ArubaOS-CX architecture?

Does this correctly describethe ArubaOS-CX architecture? Solution: The ArubaOS-CX time-series database helps to support network analytics and troubleshooting.A . YesB . NoView AnswerAnswer: B

August 30, 2021 No Comments READ MORE +

Is this correct positioning of AtubaOS-CX switches in the data center?

Is this correct positioning of AtubaOS-CX switches in the data center? Solution: Aruba CX 8325 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN(VXLAN) with Ethernet VPN (EVPN).A . YesB . NoView AnswerAnswer: B

August 30, 2021 No Comments READ MORE +

Does this correctly describe how Network Analytics Engine (NAE) agents work?

Does this correctly describe how Network Analytics Engine (NAE) agents work? Solution: Agents write data to the switch's current state database.A . YesB . NoView AnswerAnswer: A

August 29, 2021 No Comments READ MORE +

A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX)at the core?

A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX)at the core? Solution: The aggregation layer operates at Layer 2 only, and the core provides Layer 2 and Layer 3 functions.A . YesB . NoView AnswerAnswer:...

August 28, 2021 No Comments READ MORE +

Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?

Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.A . YesB . NoView...

August 28, 2021 No Comments READ MORE +

A customer's servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements?

A customer's servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements? Solution: Set up dedicated switches to connect to iSCSl arrays. Connect top of rack (ToR) switches, which will support both...

August 27, 2021 No Comments READ MORE +

Is this something that NetEdit 2.0 does after it discovers a switch?

CORRECT TEXT Is this something that NetEdit 2.0 does after it discovers a switch? Solution: It collects Information about the switch hardware.A . YesB . NoView AnswerAnswer: B

August 27, 2021 No Comments READ MORE +