What must be done before configuring any routing protocol in a VRF instance?

What must be done before configuring any routing protocol in a VRF instance?A . Assign an IP address to at least one of the interfaces assigned to the VRF instanceB . Create a routing group for each VRF instanceC . Assign each VRF instance to a routing groupD . Nothing,...

May 18, 2025 No Comments READ MORE +

Which switch mode is used to manage files and display switch information?

Which switch mode is used to manage files and display switch information?A . InterfaceB . NetworkC . ExecD . ConfigurationView AnswerAnswer: C

May 16, 2025 No Comments READ MORE +

What is the minimum multicast configuration level required on the router?

A router must be configured to allow multiple multicast servers for the same group to be presented only to ports where active listeners reside. Each listener may exclude non-preferred servers. What is the minimum multicast configuration level required on the router?A . IGMPv2 with snooping PIM-SSMB . IGMPv3 with snooping...

May 14, 2025 No Comments READ MORE +

In an NSSA, which type of LSA is used for redistribution?

In an NSSA, which type of LSA is used for redistribution?A . 3B . 4C . 5D . 7View AnswerAnswer: D

May 9, 2025 No Comments READ MORE +

ACL's have which two (2) actions?

ACL's have which two (2) actions?A . Redistribute or forwardB . Forward or eraseC . Permit or denyD . Modify or dropView AnswerAnswer: C

May 6, 2025 No Comments READ MORE +

ACLs have which two actions?

ACLs have which two actions?A . Modify or drop.B . Forward or erase.C . Redistribute or forward.D . Permit or deny.View AnswerAnswer: D

May 6, 2025 No Comments READ MORE +

Which multicast address is used by all OSPF routers?

Which multicast address is used by all OSPF routers?A . 239.0.0.4B . 239.0.0.6C . 224.0.0.5D . 224.0.0.6View AnswerAnswer: C

May 3, 2025 No Comments READ MORE +

What is a recommended configuration step for its implementation?

Multicast flood restrict is a feature enabled by default on OS10 switches to ensure that no traffic drop occurs. What is a recommended configuration step for its implementation?A . Configure the interface between the PIM routers as a dynamic multicast router portB . Enable IGMP snooping on the VLAN interfaces...

May 3, 2025 No Comments READ MORE +

What does the stratum value of 16 mean on an NTP server?

What does the stratum value of 16 mean on an NTP server?A . Device is a reference clock.B . Device has the highest synchronized accuracy.C . Device has the lowest synchronized accuracy.D . Device is unsynchronized.View AnswerAnswer: D

May 1, 2025 No Comments READ MORE +

Which command offers a solution to the inability to ping the host address from S1?

Refer to the exhibit: From S1, a ping to the host address of 192.168.37.3 is not successful. The routing table on S1 shows three directly connected networks (including the Lo0 network of S1). Network 192.168.34.0/24 and the Lo0 networks of S2 and S3 are the only OSPF-learned networks in the...

May 1, 2025 No Comments READ MORE +