Which of these conditions should be avoided in the design that could otherwise cause the peers to flap continuously?

A planned EBGP network will use OSPF to reach the EBGP peer addresses. Which of these conditions should be avoided in the design that could otherwise cause the peers to flap continuously?A . An ACL blocks TCP port 179 in one direction.B . IP addresses used to peer are also...

August 5, 2018 No Comments READ MORE +

Which VPN solution will support these design requirements?

You are working on a network design plan for a company with approximately 2000 sites. The sites will be connected using the public Internet. You plan to use private IP addressing in the network design, which will be routed without NAT through an encrypted WAN network. Some sites will be...

August 5, 2018 No Comments READ MORE +

What would be the impact of having additional ABRs per area?

During a network design review, it is recommended that the network with a single large area should be broken up into a backbone and multiple nonbackbone areas. There are differing opinions on how many ABRs are needed for each area for redundancy. What would be the impact of having additional...

August 4, 2018 No Comments READ MORE +

Which additional routing protocol would you use for the overlay routing between the group members?

You are designing a Group Encrypted Transport virtual private network solution for an existing branch network. The existing network has the following characteristics: . 50 remote sites (with an additional 30 remote sites expected over the next 3 years) . Connectivity between all sites is via Multiprotocol Label Switching Layer...

August 3, 2018 No Comments READ MORE +

Which solution meets these requirements?

A company has these requirements for access to their wireless and wired corporate LANs using 802.1x: . Client devices that are corporate assets and have been joined to the Active Directory domain are allowed access. . Personal devices must not be allowed access. . Clients and access servers must be...

August 2, 2018 No Comments READ MORE +

When the second link is added to the OSPF domain, which traffic design consideration would have the most impact on the voice traffic when both links are active?

Voice traffic between two campus enterprise networks is growing. The network designers decide to add a second 10-Mb Metro Ethernet service parallel to their original 10-Mb service in order to provide more bandwidth and diversity. The QoS profile will be the same on the new 10-Mb service due to the...

August 1, 2018 No Comments READ MORE +

Which two responses should you give?

You are the lead network designer for an enterprise company called ABC, and you are leading design discussions regarding IPv6 implementation into their existing network. A question is raised regarding older Layer 2 switches that exist in the network, and if any changes are required to these Layer 2 switches...

July 31, 2018 No Comments READ MORE +

What would be two effects of additionally implementing MPLS-TE?

A service provider creates a network design that runs MPLS in its WAN backbone using OSPF as the IGP routing protocol. What would be two effects of additionally implementing MPLS-TE? (Choose two.)A . MPLS-TE is required to reroute traffic within less than 1 second in case of a link failure...

July 27, 2018 No Comments READ MORE +

Which aspect should be changed in the design of the virtual connection?

A network designer has provisioned a router to use IPsec to encrypt the traffic over a GRE tunnel going to a web server at a remote location. From the router, the network designer can ping the web server, although the users in the office comment that they are unable to...

July 25, 2018 No Comments READ MORE +

Which technique can you use to detect forwarding path failures at a uniform rate, and reconvergence times will be consistent and predictable when your routers are in the same broadcast domain?

Which technique can you use to detect forwarding path failures at a uniform rate, and reconvergence times will be consistent and predictable when your routers are in the same broadcast domain?A . Enable BFD on your routers.B . Configure your routers with IP-SLA to ping the peer router.C . Configure...

July 25, 2018 No Comments READ MORE +