- All Exams Instant Download
Which two configuration allow peering session to from between R1 and R2?
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1: “ May 5 39:85:55.469: %TCP-6-BADAUTH ” Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid...
Which is the cause of the message?
Refer to the exhibit. An engineer configures a new HSRP group. While reviewing the HSRP status, the engineer sees the logging message generated on R2. Which is the cause of the message?A . The same virtual IP address has been configured for two HSRP groups B. The HSRP configuration has...
What does the output verify?
A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?A . The tunnel will be established and work as expected B. The tunnel destination will be known via the tunnel interface C. The tunnel keepalive is configured incorrectly because they must...
SwitchC connects HR and Sales to the Core switch However, business needs require that no traffic from the Finance VLAN traverse this switch Which command meets this requirement?
Refer to the exhibit. SwitchC connects HR and Sales to the Core switch However, business needs require that no traffic from the Finance VLAN traverse this switch Which command meets this requirement?A . SwitchC(config)#vtp pruning B. SwitchC(config)#vtp pruning vlan 110 C. SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan add 210,310...
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switch B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14. C. SPAN...
What are two differences between the RIB and the FIB? (Choose two.)
What are two differences between the RIB and the FIB? (Choose two.)A . The FIB is derived from the data plane, and the RIB is derived from the FIB. B. The RIB is a database of routing prefixes, and the FIB is the Information used to choose the egress interface...
Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?
Refer to the exhibit. Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?A . Configure a match-host type NAT pool B. Reconfigure the pool to use the 192.168 1 0 address range C. Increase the NAT pool size to support 254 usable addresses D....
What are two characteristics of VXLAN? (Choose two)
What are two characteristics of VXLAN? (Choose two)A . It uses VTEPs to encapsulate and decapsulate frames. B. It has a 12-bit network identifier C. It allows for up to 16 million VXLAN segments D. It lacks support for host mobility E. It extends Layer 2 and Layer 3 overlay...
What are two effects of this configuration?
Refer to the exhibit. What are two effects of this configuration? (Choose two.)A . R1 becomes the active router. B. R1 becomes the standby router. C. If R2 goes down, R1 becomes active but reverts to standby when R2 comes back online. D. If R1 goes down. R2 becomes active...
Which two operations are valid for RESTCONF? (Choose two.)
Which two operations are valid for RESTCONF? (Choose two.)A . HEAD B. REMOVE C. PULL D. PATCH E. ADD F. PUSHView AnswerAnswer: A,D Explanation: RESTCONF operations include OPTIONS, HEAD, GET, POST, PATCH, DELETE.
