- All Exams Instant Download
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?A . switch fabric B. VTEP C. VNID D. host switchView AnswerAnswer: C Explanation: VXLAN uses an 8-byte VXLAN header that consists of a 24-bit VNID and a few reserved bits. The VXLAN header together with the original...
Which interface or interface or interface are able to establish OSPF adjacency?
Refer to the exhibit. A network engineer configures OSPF and reviews the router configuration. Which interface or interface or interface are able to establish OSPF adjacency?A . GigabitEthemet0/1 and GigabitEthernet0/1.40 B. only GigabitEthernet0/1 C. only GigabttEthernet0/0 D. Gigabit Ethernet0/0 and GigabitEthemet0/1View AnswerAnswer: C
Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?
Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?A . ip access-list extended 10 deny tcp host 10.10.10.1 any eq 80 permit ip any any B. ip access-list extended 200 deny tcp...
Which command accomplish this task?
Refer to the exhibit. An engineer must deny Telnet traffic from the loopback interface of router R3 to the loopback interface of router R2 during the weekend hours. All other traffic between the loopback interfaces of routers R3 and R2 must be allowed at all times. Which command accomplish this...
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switch B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14. C. SPAN...
Which action reduces the user impact?
Wireless users report frequent disconnections from the wireless network. While troubleshooting a network engineer finds that after the user a disconnect, the connection re-establishes automatically without any input required. The engineer also notices these message logs. Which action reduces the user impact?A . increase the AP heartbeat timeout B. increase...
What are two differences between the RIB and the FIB? (Choose two.)
What are two differences between the RIB and the FIB? (Choose two.)A . The FIB is derived from the data plane, and the RIB is derived from the FIB. B. The RIB is a database of routing prefixes, and the FIB is the Information used to choose the egress interface...
Which two operations are valid for RESTCONF? (Choose two.)
Which two operations are valid for RESTCONF? (Choose two.)A . HEAD B. REMOVE C. PULL D. PATCH E. ADD F. PUSHView AnswerAnswer: A,D Explanation: RESTCONF operations include OPTIONS, HEAD, GET, POST, PATCH, DELETE.
Which command set configures RSPAN to capture outgoing traffic from VLAN 3 on interface GigabitEthernet 0/3 while ignoring other VLAN traffic on the same interface?
Which command set configures RSPAN to capture outgoing traffic from VLAN 3 on interface GigabitEthernet 0/3 while ignoring other VLAN traffic on the same interface?A . monitor session 2 source interface gigabitethernet0/3 rx monitor session 2 filter vlan 3 B. monitor session 2 source interface gigabitethernet0/3 rx monitor session 2...
Which command must be applied to R2 for an OSPF neighborship to form?
Which command must be applied to R2 for an OSPF neighborship to form? A . network 20.1.1.2.0.0.0.0 area 0 B. network 20.1.1.2 255.255.0.0. area 0 C. network 20.1.1.2.0.0.255.255 area 0 D. network 20.1.1.2 255.255.255 area 0View AnswerAnswer: A Explanation: The network 20.0.0.0 0.0.0.255 area 0 command on R2 did not...
