- All Exams Instant Download
Which command set must be configured on switch1 to achieve the following results on port fa0/1?
Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on switch1 to achieve the following results on port fa0/1? ✑ When a device is connected, the port transitions immediately to a forwarding state. ✑ The interface should not send or receive BPDUs....
Which data is properly formatted with JSON?
Which data is properly formatted with JSON? A) B) C) D) A . Option A B. Option B C. Option C D. Option DView AnswerAnswer: B
Which command configures the router to be the destination of jitter measurements?
An engineer is concerned with the deployment of new application that is sensitive to inter-packet delay variance. Which command configures the router to be the destination of jitter measurements?A . Router(config)# ip sla responder udp-connect 172.29.139.134 5000 B. Router(config)# ip sla responder tcp-connect 172.29.139.134 5000 C. Router(config)# ip sla responder...
Which two methods are used to reduce the AP coverage area? (Choose two)
Which two methods are used to reduce the AP coverage area? (Choose two)A . Reduce channel width from 40 MHz to 20 MHz B. Disable 2.4 GHz and use only 5 GHz. C. Reduce AP transmit power. D. Increase minimum mandatory data rate E. Enable FastlaneView AnswerAnswer: C,D
Which two commands are needed to allow for full reachability between AS 1000 and AS 2000?
Refer to the exhibit. Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two)A . R1#network 192.168.0.0 mask 255.255.0.0 B. R2#no network 10.0.0.0 255.255.255.0 C. R2#network 192.168.0.0 mask 255.255.0.0 D. R2#network 209.165.201.0 mask 255.255.192.0 E. R1#no network 10.0.0.0 255.255.255.0View AnswerAnswer: B,C
How are the different versions of IGMP compatible?
How are the different versions of IGMP compatible?A . IGMPv2 is compatible only with IGMPv1. B. IGMPv2 is compatible only with IGMPv2. C. IGMPv3 is compatible only with IGMPv3. D. IGMPv3 is compatible only with IGMPv1View AnswerAnswer: A
Which TCP setting is tuned to minimize the risk of fragmentation on a GRE/IP tunnel?
Which TCP setting is tuned to minimize the risk of fragmentation on a GRE/IP tunnel?A . MTU B. Window size C. MRU D. MSSView AnswerAnswer: D Explanation: The TCP Maximum Segment Size (TCP MSS) defines the maximum amount of data that a host is willing to accept in a single...
Which explanation of this behavior is true?
Refer to the exhibit. An engineer must block all traffic from a router to its directly connected subnet 209.165.200.0/24. The engineer applies access control list EGRESS in the outbound direction on the GigabitEthernet0/0 interface of the router However, the router can still ping hosts on the 209.165.200.0/24 subnet. Which explanation...
Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?A . wlcbostname.domain.com B. cisco-capwap-controller.domain.com C. ap-manager.domain.com D. primary-wlc.domain.comView AnswerAnswer: B Explanation: DNS: If you have configured your DHCP server to provide both...
Which encryption hashing algorithm does NTP use for authentication?
Which encryption hashing algorithm does NTP use for authentication?A . SSL B. MD5 C. AES128 D. AES256View AnswerAnswer: B Explanation: An example of configuring NTP authentication is shown below: Router1(config)#ntp authentication-key 2 md5 itexamanswers Router1(config)#ntp authenticate Router1(config)#ntp trusted-key 2
