- All Exams Instant Download
What is the process for moving a virtual machine from one host machine to another with no downtime?
What is the process for moving a virtual machine from one host machine to another with no downtime?A . live migrationB . disaster recoveryC . high availabilityD . multisite replicationView AnswerAnswer: A
Which measure is used by an NTP server to indicate its closeness to the authoritative time source?
Which measure is used by an NTP server to indicate its closeness to the authoritative time source?A . stratumB . hop countC . time zoneD . latencyView AnswerAnswer: A
What is the reason for this behavior?
Refer to the exhibit. R1(config)#ip sla 1 R1(config-ip-sla)#icmp-echo 172.20.20.2 source-interface FastEthernet1/0 R1(config-ip-sla-echo)#timeout 5000 R1(config-ip-sla-echo)#frequency 10 R1(config-ip-sla-echo)#threshold 500 R1(config)#ip sla schedule 1 start-time now life forever R1(config)#track 10 ip sla 1 reachability R1(config)#ip route 0.0.0.0 0.0.0.0 172.20.20.2 After implementing the configuration 172.20.20.2 stops replaying to ICMP echoes, but the default route...
Which two configuration changes accomplish this?
Refer to the exhibit. A network engineer must simplify the IPsec configuration by enabling IPsec over GRE using IPsec profiles. Which two configuration changes accomplish this? (Choose two)A . Apply the crypto map to the tunnel interface and change the tunnel mode to tunnel mode ipsec ipv4B . Remove all...
Why is Tunnel 0 disabled?
The following system log message is presented after a network administrator configures a GRE tunnel: Why is Tunnel 0 disabled?A . Because the tunnel cannot reach its tunnel destinationB . Because the best path to the tunnel destination is through the tunnel itselfC . Because dynamic routing is not enabledD...
Which two facts does the device output confirm?
Refer to the exhibit. Which two facts does the device output confirm? (Choose two)A . The device is using the default HSRP hello timerB . The standby device is configured with the default HSRP priorityC . The device’s HSRP group uses the virtual IP address 10.0.3.242.D . The device is...
What is the result when an active route processor fails in a design that combines NSF with SSO?
What is the result when an active route processor fails in a design that combines NSF with SSO?A . An NSF-aware device immediately updates the standby route processor RIB without churning the networkB . The standby route processor temporarily forwards packets until route convergence is completeC . An NSF-capable device...
Which two results occur if Cisco DNA Center loses connectivity to devices in the SD - Access fabric? (Choose two)
Which two results occur if Cisco DNA Center loses connectivity to devices in the SD - Access fabric? (Choose two)A . All devices reload after detecting loss of connection to Cisco DNA CenterB . Already connected users are unaffected, but new users cannot connectC . Users lose connectivityD . Cisco...
What is the wireless received signal strength indicator?
What is the wireless received signal strength indicator?A . The value of how strong the wireless signal is leaving the antenna using transmit power, cable loss, and antenna gainB . The value given to the strength of the wireless signal received compared to the noise levelC . The value of...
Which unit measures the power of a radio signal with reference to 1 milliwatt?
Which unit measures the power of a radio signal with reference to 1 milliwatt?A . dBwB . dBiC . mWD . dBmView AnswerAnswer: D
