- All Exams Instant Download
Which TCP setting is tuned to minimize the risk of fragmentation on a GRE/IP tunnel?
Which TCP setting is tuned to minimize the risk of fragmentation on a GRE/IP tunnel?A . MTUB . Window sizeC . MRUD . MSSView AnswerAnswer: D
What are two device roles in Cisco SD-Access fabric ? (Choose two.)
What are two device roles in Cisco SD-Access fabric ? (Choose two.)A . core switchB . vBond controllerC . edge nodeD . access switchE . border nodeView AnswerAnswer: CE
Drag and drop the LISP components from the left onto the functions they perform on the right. Not all options are used
DRAG DROP Drag and drop the LISP components from the left onto the functions they perform on the right. Not all options are used. View AnswerAnswer:
Where is radio resource management performed in a cisco SD-access wireless solution?
Where is radio resource management performed in a cisco SD-access wireless solution?A . DNA CenterB . control plane nodeC . wireless controllerD . Cisco CMXView AnswerAnswer: C
What is a benefit of deploying an on-premises infrastructure versus a cloud infrastructure deployment?
What is a benefit of deploying an on-premises infrastructure versus a cloud infrastructure deployment?A . faster deployment times because additional infrastructure does not need to be purchasedB . lower latency between systems that are physically located near each otherC . less power and cooling resources needed to run infrastructure on-premisesD...
Which action is the vSmart controller responsible for in an SD-WAN deployment?
Which action is the vSmart controller responsible for in an SD-WAN deployment?A . onboard vEdge nodes into the SD-WAN fabricB . distribute security information for tunnel establishment between vEdge routersC . manage, maintain, and gather configuration and status for nodes within the SD -WAN fabricD . gather telemetry data from...
Why is Tunnel 0 disabled?
The following system log message is presented after a network administrator configures a GRE tunnel: Why is Tunnel 0 disabled?A . Because the tunnel cannot reach its tunnel destinationB . Because the best path to the tunnel destination is through the tunnel itselfC . Because dynamic routing is not enabledD...
Which IP address becomes the next active next hop for 192.168.102.0/24 when 192.168.101.2 fails?
Refer to the exhibit. Which IP address becomes the next active next hop for 192.168.102.0/24 when 192.168.101.2 fails?A . 192.168.101.18B . 192.168.101.6C . 192.168.101.10D . 192.168.101.14View AnswerAnswer: A
Which behavior can be expected when the HSRP version is changed from 1 to 2?
Which behavior can be expected when the HSRP version is changed from 1 to 2?A . Each HSRP group reinitializes because the virtual MAC address has changedB . No changes occur because version 1 and 2 use the same virtual MAC OUIC . Each HSRP group reinitializes because the multicast...
Which two commands must be added to the existing configuration to accomplish this task?
Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthernet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)A . Router(config-vrf)#address-family ipv6B . Router(config-if)#ip address 192.168.1.1 255.255.255.0C . Router(config-vrf)#ip address 192.168.1.1 255.255.255.0D . Router(config-if)#address-family ipv4E ....
