- All Exams Instant Download
Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?A . wlcbostname.domain.comB . cisco-capwap-controller.domain.comC . ap-manager.domain.comD . primary-wlc.domain.comView AnswerAnswer: B Explanation: DNS: If you have configured your DHCP server to provide both...
Which command ensures that SW3 receives frames only from VLAN 50?
Refer to exhibit. VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server. Which command ensures that SW3 receives frames only from VLAN 50?A . SW1 (config)#vtp pruningB . SW3(config)#vtp mode transparentC...
What are two benefits of YANG? (Choose two.)
What are two benefits of YANG? (Choose two.)A . It enforces the use of a specific encoding format for NETCONC . It collects statistical constraint analysis information.D . It enables multiple leaf statements to exist within a leaf list.E . It enforces configuration semantics.F . It enforces configuration constraints.View AnswerAnswer:...
Which command accomplish this task?
Refer to the exhibit. An engineer must deny Telnet traffic from the loopback interface of router R3 to the loopback interface of router R2 during the weekend hours. All other traffic between the loopback interfaces of routers R3 and R2 must be allowed at all times. Which command accomplish this...
What does the status show?
Refer to the exhibit. After configurating an IPsec VPN, an engineer enters the show command to verify the ISAKMP SA status. What does the status show?A . ISAKMP SA is authenticated and can be used for Quick Mode.B . Peers have exchanged keys, but ISAKMP SA remains unauthenticated.C . VPN...
Which command set configures RSPAN to capture outgoing traffic from VLAN 3 on interface GigabitEthernet 0/3 while ignoring other VLAN traffic on the same interface?
Which command set configures RSPAN to capture outgoing traffic from VLAN 3 on interface GigabitEthernet 0/3 while ignoring other VLAN traffic on the same interface?A . monitor session 2 source interface gigabitethernet0/3 tx monitor session 2 filter vlan3B . monitor session 2 source interface gigabitethernet0/3 rx monitor session 2 filter...
How is 802.11 traffic handled in a fabric-enabled SSID?
How is 802.11 traffic handled in a fabric-enabled SSID?A . centrally switched back to WLC where the user traffic is mapped to a VXLAN on the WLCB . converted by the AP into 802.3 and encapsulated into VXLANC . centrally switched back to WLC where the user traffic is mapped...
Which two methods are used to reduce the AP coverage area? (Choose two)
Which two methods are used to reduce the AP coverage area? (Choose two)A . Reduce channel width from 40 MHz to 20 MHzB . Disable 2.4 GHz and use only 5 GHz.C . Reduce AP transmit power.D . Increase minimum mandatory data rateE . Enable FastlaneView AnswerAnswer: C D
Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?
Refer to the exhibit. Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?A . ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20B...
Which two network problems Indicate a need to implement QoS in a campus network? (Choose two.)
Which two network problems Indicate a need to implement QoS in a campus network? (Choose two.)A . port flappingB . excess jitterC . misrouted network packetsD . duplicate IP addressesE . bandwidth-related packet lossView AnswerAnswer: B, E
