Which action resolves the issue?

Refer to the exhibit. An engineer cannot log in to the Cisco IMC page of the Cisco UCS C220 server. Which action resolves the issue?A . Replace the self-signed certificate that is installed on the Cisco IMC with a server certificate that is signed from the client corporate certificate "authority.B...

December 4, 2020 No Comments READ MORE +

What occurs when the new uplinks are added to the uplink?

An engineer discovers that an NPV/NPIV uplink experiences a heavy load and plans to add more uplinks. What occurs when the new uplinks are added to the uplink?A . New and existing connections automatically use the new uplinks.B . All connections must be reset before the new uplinks are used.C...

December 3, 2020 No Comments READ MORE +

Which action resolves the issue?

An engineer troubleshoots a VXLAN EVPN data center. The applications in the data center fail to reach the DNS server that is located at IP 10.10.10.10. The engineer examines the BGP EVPN routing table and notes that the IP prefix route that covers the DNS server is missing. Which action...

December 2, 2020 No Comments READ MORE +

Which action recovers the module?

An IOM fails during a firmware upgrade and is unresponsive. Which action recovers the module?A . Restore UCSM configuration from backup.B . Roll back to the previous firmware.C . Use AutoInstall to reinstall the firmware.D . From the peer IOM, reset the faulty module.View AnswerAnswer: B

April 11, 2020 No Comments READ MORE +

Which two requirements must an engineer verify about switch connectivity to solve the problem?

An engineer is troubleshooting a fabric discovery failure. Which two requirements must an engineer verify about switch connectivity to solve the problem? (Choose two.)A . A Cisco APIC must be attached to a spine node only.B . A Cisco APIC must be attached to leaf nodes.C . Spine nodes must...

April 11, 2020 No Comments READ MORE +

Which EVPN routes are expected on this connection?

An engineer is troubleshooting a packet flow from an access leaf to spine. Which EVPN routes are expected on this connection?A . EVPN Type 1-5B . EVPN Type 0,9,15C . EVPN Type 9-15D . EVPN Type 0,16View AnswerAnswer: A

April 10, 2020 No Comments READ MORE +

Which two actions need to be attempted to resolve the issue?

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)A . Configure the NVE interfaces to be Up on both switches.B . Set a different distributed gateway virtual MAC address.C . Set...

April 10, 2020 No Comments READ MORE +

Which action should be performed on the Cisco Nexus switch ports to resolve this issue?

The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed on the Cisco Nexus switch ports to resolve this issue?A . Turn on lacp suspend-individual.B . Turn...

April 10, 2020 No Comments READ MORE +

Which two actions optimize the traffic?

A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)A . Disable first-hop redundancy.B . Filter HSRP traffic...

April 9, 2020 No Comments READ MORE +

Which action resolves the issue?

Refer to the exhibit. A web browser displays a “not secure” warning message when accessing the web interface of Cisco UCS Manager. Which action resolves the issue?A . Load third-party certificate to UCS Manager.B . Use the correct TCP port for HTTPD . Use a supported web browser.E . Use...

April 9, 2020 No Comments READ MORE +