Which action should be taken to resolve this issue?

Refer to the exhibit. An IT staff member comes into the office during normal office hours and cannot access devices through SSH. Which action should be taken to resolve this issue?A . Modify the access list to use the correct IP address.B . Configure the correct time range.C . Modify...

August 20, 2021 No Comments READ MORE +

What action will fix the issue?

Refer to the exhibit. R1 is connected with R2 via GigabitEthernet0/0, and R2 cannot ping R1 . What action will fix the issue?A . Fix route dampening configured on the router.B . Replace the SFP module because it is not supported.C . Fix IP Event Dampening configured on the interface.D...

August 19, 2021 No Comments READ MORE +

Which action allows traffic to use both paths?

Refer to the exhibit. R2 has two paths to reach 192.168.13.0/24. but traffic is sent only through R3 . Which action allows traffic to use both paths?A . Configure the bandwidth 2000 command under interface FastEthernet0/0 on R2B . Configure the delay 1 command under interface FastEthernet0/0 on R2C ....

August 19, 2021 No Comments READ MORE +

Which action ensures consistency between the two times?

Refer to the exhibit. An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries . Which action ensures consistency between the two times?A . Configure the service timestamps log uptime command in global...

August 19, 2021 No Comments READ MORE +

Which action resolves the issue?

Refer to the exhibit. The OSPF routing protocol is redistributed into the BGP routing protocol, but not all the OSPF routes are distributed into BGP. Which action resolves the issue?A . Include the word external in the redistribute commandB . Use a route-map command to redistribute OSPF external routes defined...

August 19, 2021 No Comments READ MORE +

Which Ipv6 first-hop security feature helps to minimize denial of service attacks?

Which Ipv6 first-hop security feature helps to minimize denial of service attacks?A . IPv6 Router Advertisement GuardB . IPv6 Destination GuardC . DHCPv6 GuardD . IPv6 MAC address filteringView AnswerAnswer: B Explanation: The Destination Guard feature helps in minimizing denial-of-service (DoS) attacks. It performs address resolutions only for those addresses...

August 19, 2021 No Comments READ MORE +

Which command must the engineer run to correct the configuration?

An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install . Which command must the engineer run to correct the configuration?A . sudo maglev-config updateB . sudo maglev install config updateC . sudo maglev reinstallD . sudo update config installView AnswerAnswer: A

August 18, 2021 No Comments READ MORE +

Which configuration resolves the issue?

Refer to Exhibit: AS 111 wanted to use AS 200 as the preferred path for 172.20.5.0/24 and AS 100 as the backup. After the configuration, AS 100 is not used for any other routes . Which configuration resolves the issue?A . route-map SETLP permit 10 match ip address prefix-list PLIST1...

August 17, 2021 No Comments READ MORE +

Which command must be configured first to troubleshoot this issue?

While troubleshooting connectivity issues to a router, these details are noticed: ✑ Standard pings to all router interfaces, including loopbacks, are successful. ✑ Data traffic is unaffected. ✑ SNMP connectivity is intermittent. ✑ SSH is either slow or disconnects frequently. Which command must be configured first to troubleshoot this issue?A...

August 17, 2021 No Comments READ MORE +

Which statement about MPLS LDP router ID is true?

Which statement about MPLS LDP router ID is true?A . If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.B . The loopback with the highest IP address is selected as the router ID . The MPLS LDP router ID must...

August 17, 2021 No Comments READ MORE +